Search results
Results From The WOW.Com Content Network
The difference between a layer-3 switch and a router is the way the device is making the routing decision. Conventionally, routers use microprocessors to make forwarding decisions in software, while the switch performs only hardware-based packet switching (by specialized ASICs with the help of content-addressable memory).
A network switch is a multiport network bridge that uses MAC addresses to forward data at the data link layer (layer 2) of the OSI model. Some switches can also forward data at the network layer (layer 3) by additionally incorporating routing functionality. Such switches are commonly known as layer-3 switches or multilayer switches. [2]
[2]: 2-8 - 2-9 For all nodes, except a chosen reference node, the node voltage is defined as the voltage drop from the node to the reference node. Therefore, there are N-1 node voltages for a circuit with N nodes. [2]: 2-10 In principle, nodal analysis uses Kirchhoff's current law (KCL) at N-1 nodes to get N-1 independent equations. Since ...
Current mode logic (CML), or source-coupled logic (SCL), is a digital design style used both for logic gates and for board-level digital signaling of digital data.. The basic principle of CML is that current from a constant current generator is steered between two alternate paths depending on whether a logic zero or logic one is being represented.
Switching circuit theory is the mathematical study of the properties of networks of idealized switches. Such networks may be strictly combinational logic, in which their output state is only a function of the present state of their inputs; or may also contain sequential elements, where the present state depends on the present state and past states; in that sense, sequential circuits are said ...
In circuit analysis, the edges of the graph are called branches. The dots are called the vertices of the graph and represent the nodes of the network. Node and vertex are terms that can be used interchangeably when discussing graphs of networks. Figure 2.2 shows a graph representation of the circuit in figure 2.1. [22]
2 1 0 0 0 0 0 0 OTU2 10 10.7 Transports an OC-192, STM-64 or wide area network (WAN) physical layer (PHY) for 10 Gigabit Ethernet (10GBASE-W) 8 4 1 0 0 0 0 0 OTU2e [4] 10.5 11.1 Transports a 10 Gigabit Ethernet local area network (LAN) PHY coming from IP/Ethernet switches and routers at full line rate (10.3 Gbit/s). This is specified in G.Sup43 ...
A silicon-controlled switch (SCS) behaves nearly the same way as an SCR; but there are a few differences. Unlike an SCR, an SCS switches off when a positive voltage/input current is applied to another anode gate lead. Unlike an SCR, an SCS can be triggered into conduction when a negative voltage/output current is applied to that same lead.