Search results
Results From The WOW.Com Content Network
In geometry, a spherical segment is the solid defined by cutting a sphere or a ball with a pair of parallel planes. It can be thought of as a spherical cap with the top truncated, and so it corresponds to a spherical frustum. The surface of the spherical segment (excluding the bases) is called spherical zone. Geometric parameters for spherical ...
The curved surface area of the spherical segment bounded by two parallel disks is the difference of surface areas of their respective spherical caps. For a sphere of radius r {\displaystyle r} , and caps with heights h 1 {\displaystyle h_{1}} and h 2 {\displaystyle h_{2}} , the area is
The curved surface area of the spherical sector (on the surface of the sphere, excluding the cone surface) is =. It is also A = Ω r 2 {\displaystyle A=\Omega r^{2}} where Ω is the solid angle of the spherical sector in steradians , the SI unit of solid angle.
The surface area, or properly the ... and when a point in the ball is obtained scaling it up to the spherical surface by the ... draw a segment between each point ...
The sphere has the smallest surface area of all surfaces that enclose a given volume, and it encloses the largest volume among all closed surfaces with a given surface area. [11] The sphere therefore appears in nature: for example, bubbles and small water drops are roughly spherical because the surface tension locally minimizes surface area.
The external surface area A of the cap equals r2 only if solid angle of the cone is exactly 1 steradian. ... The solid angle subtended by a segment of a spherical cap ...
The sum of the angles of a spherical triangle is not equal to 180°. A sphere is a curved surface, but locally the laws of the flat (planar) Euclidean geometry are good approximations. In a small triangle on the face of the earth, the sum of the angles is only slightly more than 180 degrees. A sphere with a spherical triangle on it.
The spherical coordinates of a point P then are defined as follows: The radius or radial distance is the Euclidean distance from the origin O to P. The inclination (or polar angle) is the signed angle from the zenith reference direction to the line segment OP. (Elevation may be used as the polar angle instead of inclination; see below.)