Search results
Results From The WOW.Com Content Network
Ohm's law states that the electric current through a conductor between two points is directly proportional to the voltage across the two points. Introducing the constant of proportionality, the resistance, [1] one arrives at the three mathematical equations used to describe this relationship: [2] where I is the current through the conductor, V ...
Karl Christian von Langsdorf. Georg Simon Ohm (/ oʊm /; [1] German: [ˈɡeːɔʁk ˈʔoːm]; [2][3] 16 March 1789 – 6 July 1854) was a German physicist and mathematician. As a school teacher, Ohm began his research with the new electrochemical cell, invented by Italian scientist Alessandro Volta. Using equipment of his own creation, Ohm ...
Ohm's law is satisfied when the graph is a straight line through the origin. Therefore, the two resistors are ohmic, but the diode and battery are not. For many materials, the current I through the material is proportional to the voltage V applied across it: over a wide range of voltages and currents. Therefore, the resistance and conductance ...
Electric current. A simple electric circuit, where current is represented by the letter i. The relationship between the voltage (V), resistance (R), and current (i or I) is V=IR; this is known as Ohm's law. Common symbols. I.
The formula is a combination of Ohm's law and Joule's law: = = =, where P is the power, R is the resistance, V is the voltage across the resistor, and I is the current through the resistor. A linear resistor has a constant resistance value over all applied voltages or currents; many practical resistors are linear over a useful range of currents.
The SI unit of electrical resistivity is the ohm - metre (Ω⋅m). [1][2][3] For example, if a 1 m3 solid cube of material has sheet contacts on two opposite faces, and the resistance between these contacts is 1 Ω, then the resistivity of the material is 1 Ω⋅m. Electrical conductivity (or specific conductance) is the reciprocal of ...
A matrix version of Kirchhoff's current law is the basis of most circuit simulation software, such as SPICE. The current law is used with Ohm's law to perform nodal analysis. The current law is applicable to any lumped network irrespective of the nature of the network; whether unilateral or bilateral, active or passive, linear or non-linear.
For example, a 10 ohm resistor connected in parallel with a 5 ohm resistor and a 15 ohm resistor produces 1 / 1/10 + 1/5 + 1/15 ohms of resistance, or 30 / 11 = 2.727 ohms. A resistor network that is a combination of parallel and series connections can be broken up into smaller parts that are either one or the other.