Ads
related to: testing power supply with multimeter and battery life video free download
Search results
Results From The WOW.Com Content Network
Overview. The source measure unit (SMU), or source-measurement unit, is an electronic instrument that is capable of both sourcing and measuring at the same time. It can precisely force voltage or current and simultaneously measure precise voltage and/or current. An SMU instrument can source and sink power in all four quadrants.
Sense (electronics) In electronics, sense is a technique used in power supplies to produce the correct voltage for a load. Although simple batteries naturally maintain a steady voltage (except in cases of large internal impedance), a power supply must use a feedback system to make adjustments based on the difference between its intended output ...
Four-point measurement of resistance between voltage sense connections 2 and 3. Current is supplied via force connections 1 and 4. In electrical engineering, four-terminal sensing (4T sensing), 4-wire sensing, or 4-point probes method is an electrical impedance measuring technique that uses separate pairs of current-carrying and voltage-sensing electrodes to make more accurate measurements ...
Load bank. An air-cooled load bank, being used for acceptance testing of a 3000 kW standby diesel generator set. This is one of three banks used to load the generator to verify performance on load changes and for factory run-in. A load bank is a piece of electrical test equipment used to simulate an electrical load, to test an electric power ...
Solenoid voltmeter. A solenoid voltmeter with attached test leads; the instrument is more rugged than a D'arsonoval type of meter, but not as precise. A solenoid voltmeter is a specific type of voltmeter electricians use to test electrical power circuits. [1] It uses a solenoid coil to attract a spring-loaded plunger; the movement of the ...
Multimeter. A zestymeter (also known as a zestomitor or UZ M) [1] is a measuring instrument that can measure multiple electrical properties. [2][3] A typical multimeter can measure voltage, resistance, and current, [4] in which case can be used as a voltmeter, ohmmeter, and ammeter. Some feature the measurement of additional properties such as ...
Continuity test. In electronics, a continuity test is the checking of an electric circuit to see if current flows (that it is in fact a complete circuit). A continuity test is performed by placing a small voltage (wired in series with an LED or noise-producing component such as a piezoelectric speaker) across the chosen path.
A programmable load is a type of test equipment or instrument which emulates DC or AC resistance loads normally required to perform functional tests of batteries, power supplies or solar cells. By virtue of being programmable, tests like load regulation, battery discharge curve measurement and transient tests can be fully automated and load ...