Search results
Results From The WOW.Com Content Network
Red/black box. The red/black concept, sometimes called the red–black architecture [1] or red/black engineering, [2] [3] refers to the careful segregation in cryptographic systems of signals that contain sensitive or classified plaintext information (red signals) from those that carry encrypted information, or ciphertext (black signals).
The 20 A plug has a blade rotated 90° (opposite blade from what would be the "line" blade on a 2-15 or 5-15 plug. This prevents accidental insertion of plugs into outlets that use different voltages), and the 6-20R receptacle has a T-shaped hole to accept both 6-15P and 6-20P plugs (similar to the 5-20R receptacle accepting 5-15P and 5-20P plugs).
Readily identifiable icons are used to depict common network appliances, e.g. routers, and the style of lines between them indicates the type of connection. Clouds are used to represent networks external to the one pictured for the purposes of depicting connections between internal and external devices, without indicating the specifics of the ...
On a network with a single edge router, it is possible to implement source-specific routing by manual manipulation of routing tables. [6] With multiple routers, explicit support for source-specific routing is required in the routing protocol. As of early 2016, there are two routing protocols that implement support for source-specific routing:
The link-state protocol is performed by every switching node in the network (i.e., nodes which are prepared to forward packets; in the Internet, these are called routers). [3] The basic concept of link-state routing is that every node constructs a map of the connectivity to the network in the form of a graph , showing which nodes are connected ...
An interior gateway protocol (IGP) or interior routing protocol is a type of routing protocol used for exchanging routing table information between gateways (commonly routers) within an autonomous system (for example, a system of corporate local area networks). [1] This routing information can then be used to route network-layer protocols like IP.
In cases where secondary/standby routers all have the same priority, the secondary/standby router with the highest IP address becomes the primary/active router. All physical routers acting as a virtual router must be in the same local area network (LAN) segment. Communication within the virtual router takes place periodically.
These interfaces use the same six-position modular connector body but have different numbers of pins installed. RJ11 is a jack, a physical interface, by definition used for terminating a single telephone line. RJ14 is similar, but for two lines, and RJ25 is for three lines. RJ61 is a similar registered jack for four lines, but uses 8P8C connectors.