Ads
related to: 7k torsion axle with brakes conversion kit harbor freight car heater
Search results
Results From The WOW.Com Content Network
The Marmon-Herrington Company, Inc. is an American manufacturer of axles and transfer cases for trucks and other vehicles. [1] Earlier, the company built military vehicles and some tanks during World War II, and until the late 1950s or early 1960s was a manufacturer of trucks and trolley buses.
An early application of a torsion bar in an American car was by Hudson Motor Car Company of Detroit who had introduced the innovative front axle flex suspension in 1934 Hudson and Terraplane cars and realized for 1935 that a transverse torsion bar linked to the rear axle was needed as an anti-roll bar to stabilize the cars. The single torsion ...
Prony brake dynamometers at a tractor contest in 1910 Schematic of a Prony brake Actual Prony Brake built for testing 5HP Steam Engine. The Prony brake is a simple device invented by Gaspard de Prony in 1821 to measure the torque produced by an engine. The term "brake horsepower" is one measurement of power derived from this method of measuring ...
The Dana 70 axle only came with 5.13:1, 4.88,5.31 [citation needed] gear ratios and had a GAWR of [citation needed] these axles were rated at 7-9klbs as seen on 5500 door stickers. They differ greatly from previous Dana 70 front axles, some of the major differences being the use of 1550 Universal Joints and being a high pinion, reverse cut axle.
The Dana Holding Corporation manufactured the TTB axle for Ford. It uses a universal joint in the center that allows the wheels to move independently of each other. The differential is offset to the driver's side, and a slip yoke is used on the long axle side to allow the shaft to change length.
The M939 series uses 11:00 R20 tires with two tires per side per axle in the rear (rear tandem duals). This allows a heavy load to be carried on improved roads and most US trucks in the past have used them. The M939A1 and M939A2 series instead use oversized 14:00 R20 tires with a single tire on each side per axle, still with a tandem setup.