When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Furnace (central heating) - Wikipedia

   en.wikipedia.org/wiki/Furnace_(central_heating)

   These furnaces were still big and bulky compared to modern furnaces, and had heavy-steel exteriors with bolt-on removable panels. Energy efficiency would range anywhere from just over 50% to upward of 65% AFUE. This style furnace still used large, masonry or brick chimneys for flues and was eventually designed to accommodate air-conditioning ...

3. Piping and instrumentation diagram - Wikipedia

   en.wikipedia.org/wiki/Piping_and_instrumentation...

   Furnace: Cooling tower: Heat exchanger: Coil heat exchanger: Cooler: Plate & frame heat exchanger: Double pipe heat exchanger Fixed straight tubes heat exchanger: U-shaped tubes heat exchanger Spiral heat exchanger Covered gas vent Curved gas vent Air filter: Funnel or tundish: Steam trap: Viewing glass Pressure reducing valve: Valve: Gate ...

4. Damper (flow) - Wikipedia

   en.wikipedia.org/wiki/Damper_(flow)

   Redundancy: If one zone furnace fails, the others can remain working; Disadvantages: Cost. Furnaces cost much more than zone dampers; Power consumption. Operating furnaces draw power whereas a zone damper only draws power while in motion from one state to the other (or, in some cases, a very small amount of power while holding closed)

5. Forced-air - Wikipedia

   en.wikipedia.org/wiki/Forced-air

   A forced-air central heating system is one which uses air as its heat transfer medium. These systems rely on ductwork, vents, and plenums as means of air distribution, separate from the actual heating and air conditioning systems. The return plenum carries the air from several large return grills (vents) to a central air handler for re-heating ...

6. Register (air and heating) - Wikipedia

   en.wikipedia.org/wiki/Register_(air_and_heating)

   Ideally, a room will have both heating and cooling registers. In practice, cost considerations usually require that heating and cooling be provided by the same register. In such cases, heating most often takes precedence over cooling, and registers are usually found close to the floor. [7] For heating purposes, a floor register is preferred.

7. Forced-air gas - Wikipedia

   en.wikipedia.org/wiki/Forced-air_gas

   Older furnaces sometimes relied on gravity instead of a blower to circulate air. [1]Gas-fired forced-air furnaces have a burner in the furnace fueled by natural gas.A blower forces cold air through a heat exchanger and then through duct-work that distributes the hot air through the building. [2]