Ads
related to: class 1 load manager p/n 101709 4 10 5 ribbon connectors
Search results
Results From The WOW.Com Content Network
High-Speed 1760 specifies a gigabit-speed interface based on Fibre Channel, operating at 1.0625 Gbit/s over a pair of 75 ohm coax cables. The Fibre Channel upper layer protocols for High-Speed 1760 are FC-AE-1553, based on MIL-STD-1553, for command and control messages and file transfers; and FC-AV for video and audio. [1]
A MIL-DTL-38999 circular connector plated with a nickel–teflon composite. Left: plug (male) type connector; Right: receptacle (female) type connector) Electrical or fiber-optic connectors used by U.S. Department of Defense were originally developed in the 1930s for severe aeronautical and tactical service applications, and the Type "AN" series set the standard for modern military circular ...
Ribbon cable with three connectors. Ribbon cables are usually specified by two numbers: the spacing or pitch of the conductors, and the number of conductors or ways. A spacing of 0.05 inch (1.27 mm) is the most usual, allowing for a two-row connector with a pin spacing of 0.1 inch (2.54 mm).
Cross section of an N connector mated pair. The interface specifications for the N and many other connectors are referenced in MIL-STD-348. [3] Originally, the connector was designed to carry signals at frequencies up to 1 GHz in military applications, but today's common Type N easily handles frequencies up to 11 GHz.
The pilot pin is located in the centre of main contact circle on 4- and 5-pin connectors. On 3-pin (2P+E) connectors, it is located on the contact circle opposite the ground pin. The other connectors are located 105° on either side of the earth pin, rather than 120° as in the smaller variants, to make room for the pilot pin.
The de facto standard 8 inch FDD interface is based upon the Shugart Associates models SA800/801 [3] FDDs and models SA850/851 [4] FDDs. [5]: 171 The signal interface uses a 50-pin PCB edge connector which mates to a flat ribbon cable connector. Separate connectors are provided for both AC and DC power, as many 8 inch drives used AC spindle motors.