Search results
Results From The WOW.Com Content Network
The ignition switch was designed to remove power from the vehicle's airbags when in the Off or Accessory mode. [11] Therefore, this was a safety hazard: If the switch changed from Run to Accessory and the vehicle was involved in an accident, it would no longer have power to release the airbags, and it would be difficult for the driver to steer ...
A check engine light or malfunction indicator lamp (MIL), is a tell-tale that a computerized engine-management system uses to indicate a malfunction or problem with the vehicle ranging from minor (such as a loose gas cap) to serious (worn spark plugs, engine problems or a faulty oil valve, etc.).
The ignition locking system may be sometimes bypassed by disconnecting the wiring to the switch and manipulating it directly; this is known as hotwiring. Ignition switches are generally a simple repair that can be completed without much knowledge. They are mainly vehicle specific and plug and play.
Pressure in cylinder pattern in dependence on ignition timing: (a) - misfire, (b) too soon, (c) optimal, (d) too late. In a spark ignition internal combustion engine, ignition timing is the timing, relative to the current piston position and crankshaft angle, of the release of a spark in the combustion chamber near the end of the compression stroke.
Low-speed pre-ignition (LSPI), also known as stochastic pre-ignition (SPI), [1] is a pre-ignition event that occurs in gasoline vehicle engines when there is a premature ignition of the main fuel charge. [2] LSPI is most common in certain turbocharged direct-injection vehicles operating in low-speed and high-load driving conditions. [3]
An ignition coil is used in the ignition system of a spark-ignition engine to transform the battery voltage to the much higher voltages required to operate the spark plug(s). The spark plugs then use this burst of high-voltage electricity to ignite the air-fuel mixture. The ignition coil is constructed of two sets of coils wound around an iron ...
A tracer-gas leak testing method is a nondestructive testing method that detects gas leaks.A variety of methods with different sensitivities exist. Tracer-gas leak testing is used in the petrochemical industry, the automotive industry, the construction industry [1] and in the manufacture of semiconductors, among other uses.
Hot-wiring is the process of bypassing a motor vehicle's ignition switch and thus starting it without the key.It is often utilized during a vehicle theft. [1] However, a legitimate vehicle owner who has lost a vehicle key or starting a vehicle with inoperable ignition switch (e.g. in run-down old cars) may also use this process.