Ads
related to: so 239 bulkhead feed through tube amp kit
Search results
Results From The WOW.Com Content Network
The connector reliably carries signals at frequencies up to 100 MHz. [1] The coupling shell has a 5 / 8 inch 24 tpi UNEF standard thread. [4] The most popular cable plug and corresponding chassis-mount socket carry the old Signal Corps labels PL-259 (plug #259) and SO-239 (socket #239). [12]
E.H. Scott Radio Laboratories is sometimes confused with H.H. Scott. E.H. Scott was founded in 1925 by Chicago resident Ernest H. Scott. Its first product was the World's Record Super 8, a TRF (tuned radio frequency) design with typical harness wiring with 16 gauge silvered solid core copper wire employed in an array configuration that was typical to radios at the time. This construction ...
The FM-5 tuner was offered as was the SCA-80 integrated amplifier in the early 1970s time line. Dynaco's solid-state kits were different from the popular Heathkit products (and Dynaco's own vacuum tube kits) because of their preassembled circuit boards. These boards were wired at the factory, tested and packaged with the unassembled chassis.
Compared to modern electrical wiring standards, these are the main technical shortcomings of knob-and-tube wiring methods: never included a safety grounding conductor; did not confine switching to the hot conductor (the so-called Carter system prohibited as of 1923 places electrical loads across the common terminals of a three-way switch pair)
Added later was the rugged DH-500 stereo amplifier, which was rated at 255 watts per channel and saw great success in home, studio, and live environments. The amplifiers were notable for their early use of new, more-powerful MOSFETs to enable much lower distortion at higher power, in a very economical fashion.
A valve amplifier or tube amplifier is a type of electronic amplifier that uses vacuum tubes to increase the amplitude or power of a signal. Low to medium power valve amplifiers for frequencies below the microwaves were largely replaced by solid state amplifiers in the 1960s and 1970s.
A feedthrough is a conductor used to carry a signal through an enclosure or printed circuit board. Like any conductor, it has a small amount of capacitance . A "feedthrough capacitor" has a guaranteed minimum value of shunt capacitance [ clarify ] built in it and is used for bypass purposes in ultra-high-frequency applications. [ 1 ]
The current-feedback operational amplifier (CFOA or CFA) is a type of electronic amplifier whose inverting input is sensitive to current, rather than to voltage as in a conventional voltage-feedback operational amplifier (VFA). The CFA was invented by David Nelson at Comlinear Corporation, and first sold in 1982 as a hybrid amplifier, the CLC103.