When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Drill bit - Wikipedia

   en.wikipedia.org/wiki/Drill_bit

   The correct tool to start a traditionally drilled hole (a hole drilled by a high-speed steel (HSS) twist drill bit) is a spotting drill bit (or a spot drill bit, as they are referenced in the U.S.). The included angle of the spotting drill bit should be the same as, or greater than, the conventional drill bit so that the drill bit will then ...

3. Non-explosive demolition agents - Wikipedia

   en.wikipedia.org/wiki/Non-explosive_demolition...

   To use non-explosive demolition agents in demolition or quarrying, holes are drilled in the base rock as they would be for use with conventional explosives. A slurry mixture of the non-explosive demolition agent and water is poured into the drill holes. Over the next few hours the slurry expands, cracking the rock in a pattern somewhat like the ...

4. Drifter drill - Wikipedia

   en.wikipedia.org/wiki/Drifter_drill

   Rock drill mounted on a tripod. The large objects on the legs are weights to anchor it down into position. In reciprocating power drills, the drilling cylinder is mounted on a feed-screw, such that as the hole is drilled and the drilling point recedes from the rock face, the drill-bit continues to move into it, while the anchor point (on the tripod or column) remains in place. [11]

5. Lewis (lifting appliance) - Wikipedia

   en.wikipedia.org/wiki/Lewis_(lifting_appliance)

   The split-pin lewis is similar to the chain-linked lewis in that it uses a scissor-like action to produce friction against the inside of the lewis hole. The two legs, semicircular in section, lie side-by-side, and fit inside a hole drilled in the stone. This type of lewis seating is the simplest to prepare, requiring a single drilled hole.

6. Ceramic tile cutter - Wikipedia

   en.wikipedia.org/wiki/Ceramic_tile_cutter

   The ceramic tile cutter works by first scratching a straight line across the surface of the tile with a hardened metal wheel and then applying pressure directly below the line and on each side of the line on top. Snapping pressure varies widely, some mass-produced models exerting over 750 kg.

7. Plug and feather - Wikipedia

   en.wikipedia.org/wiki/Plug_and_feather

   A number of holes are then cut or drilled into the stone face along the scored line approximately 10 to 20 centimetres (3.9 to 7.9 in) apart. Plug and feather sets are inserted in the holes, with the "ears" of the feathers facing the direction of the desired split. The plugs are then struck with a hammer in sequence.