Search results
Results From The WOW.Com Content Network
Ping time is an average time measured in milliseconds (ms). [ citation needed ] The lower one's ping is, the lower the latency is and the less lag the player will experience. High ping and low ping are commonly used terms in online gaming, where high ping refers to a ping that causes a severe amount of lag; while any level of ping may cause lag ...
RTT is a measure of the amount of time taken for an entire message to be sent to a destination and for a reply to be sent back to the sender. The time to send the message to the destination in its entirety is known as the network latency, and thus RTT is twice the latency in the network plus a processing delay at the destination.
Typically, TCP Keepalives are sent every 45 or 60 seconds on an idle TCP connection, and the connection is dropped after 3 sequential ACKs are missed. This varies by host, e.g. by default, Windows PCs send the first TCP Keepalive packet after 7200000ms (2 hours), then send 5 Keepalives at 1000ms intervals, dropping the connection if there is no ...
The round-trip time or ping time is the time from the start of the transmission from the sending node until a response (for example an ACK packet or ping ICMP response) is received at the same node. It is affected by packet delivery time as well as the data processing delay , which depends on the load on the responding node.
The original DARPA Internet Protocol's RFC describes [1]: §1.4 TTL as: . The Time to Live is an indication of an upper bound on the lifetime of an internet datagram.It is set by the sender of the datagram and reduced at the points along the route where it is processed.
A ping flood is a simple denial-of-service attack where the attacker overwhelms the victim with ICMP "echo request" packets. [1] This is most effective by using the flood option of ping which sends ICMP packets as fast as possible without waiting for replies.
The ICMP header starts after the IPv4 header and is identified by its protocol number, 1. [6] All ICMP packets have an eight-byte header and variable-sized data section. The first four bytes of the header have fixed format, while the last four bytes depend on the type and code of the ICMP packet.
Display lag is a phenomenon associated with most types of liquid crystal displays (LCDs) like smartphones and computers and nearly all types of high-definition televisions (HDTVs).