Search results
Results From The WOW.Com Content Network
For example, Plücker coordinates are used to determine the position of a line in space. [11] When there is a need, the type of figure being described is used to distinguish the type of coordinate system, for example the term line coordinates is used for any coordinate system that specifies the position of a line.
Each axis is usually named after the coordinate which is measured along it; so one says the x-axis, the y-axis, the t-axis, etc. Another common convention for coordinate naming is to use subscripts, as ( x 1 , x 2 , ..., x n ) for the n coordinates in an n -dimensional space, especially when n is greater than 3 or unspecified.
More technically, the abscissa of a point is the signed measure of its projection on the primary axis. Its absolute value is the distance between the projection and the origin of the axis, and its sign is given by the location on the projection relative to the origin (before: negative; after: positive). Similarly, the ordinate of a point is the ...
Example of the use of descriptive geometry to find the shortest connector between two skew lines. The red, yellow and green highlights show distances which are the same for projections of point P. Given the X, Y and Z coordinates of P, R, S and U, projections 1 and 2 are drawn to scale on the X-Y and X-Z planes, respectively.
Similarly, if the exponent of y is always even in the equation of the curve then the x-axis is an axis of symmetry for the curve. If the sum of the degrees of x and y in each term is always even or always odd, then the curve is symmetric about the origin and the origin is called a center of the curve. Determine any bounds on the values of x and y.
The horizontal direction, usually labelled the X direction, [15] is then automatically determined. Or, one can do it the other way around, i.e., nominate the x-axis, in which case the y-axis is then automatically determined. There is no special reason to choose the horizontal over the vertical as the initial designation: the two directions are ...
Two methods of construction are obvious from Fig. 3-2: the x-axis is drawn perpendicular to the ct′-axis, the x′ and ct-axes are added at angle φ; and the x′-axis is drawn at angle θ with respect to the ct′-axis, the x-axis is added perpendicular to the ct′-axis and the ct-axis perpendicular to the x′-axis. In a Minkowski diagram ...
A log–log plot of y = x (blue), y = x 2 (green), and y = x 3 (red). Note the logarithmic scale markings on each of the axes, and that the log x and log y axes (where the logarithms are 0) are where x and y themselves are 1. Comparison of linear, concave, and convex functions when plotted using a linear scale (left) or a log scale (right).