Ads
related to: push rod suspension system for motorcycles
Search results
Results From The WOW.Com Content Network
In 1972, Yamaha introduced the Mono-Shock single shock absorber rear suspension system on their motorcycles competing in the Motocross World Championships. [16] The suspension which was designed by Lucien Tilkens, became so successful that other motorcycle manufacturers developed their own single shock absorber designs. [16]
As such, push-rod suspension systems allow for much greater high-speed stability, much lower levels of body-roll, and a much lower centre of gravity for the vehicle. [7] For pull-rod suspension systems, the only difference is the orientation of the rocker arms. In a push-rod system, the rocker arms are placed at the highest point in the assembly.
As the wheel rises, the push rod compresses the internal spring via a pivot or pivoting system. The opposite arrangement, a "pull rod", will pull on the rod during bump travel, and the rod must be attached to the top of the upright, angled downward. Locating the spring and damper inboard increases the total mass of the suspension, but reduces ...
The front suspension is usually built into the front fork and may consist of telescoping tubes called fork tubes which contain the suspension inside or some multibar linkage that incorporate the suspension externally. There is another type of front suspension system which is Earles type which highly used in off-road motorcycles. [3]
WP rear shock unit on a KTM 950 Adventure in 2007. WP Suspension GmbH is a manufacturer of components for motorcycle suspension systems based in Austria. The company was founded in 1977 by Wim Peters in Malden, Netherlands [1] and is amongst the largest manufacturers of suspension components for motorcycles. [2]
The motorcycle is powered by a newly developed air and oil-cooled 1,802 cc (110.0 cu in), 91 hp (68 kW) two-cylinder boxer. It is the largest two-cylinder boxer engine for motorcycles built by BMW so far. The valves of the four-stroke engine are controlled by tappets, push rods above the cylinders and rocker arms.