Search results
Results From The WOW.Com Content Network
IEEE 1451 is a set of smart transducer interface standards developed by the Institute of Electrical and Electronics Engineers (IEEE) Instrumentation and Measurement Society's Sensor Technology Technical Committee describing a set of open, common, network-independent communication interfaces for connecting transducers (sensors or actuators) to microprocessors, instrumentation systems, and ...
In 1993, System Sensor filed a patent for a new strobe that was ADA compliant. It featured a clear lens and a reflector to distribute the light as well as higher candela options, the minimum being 15 candela. Soon after, System Sensor implemented the ADA-compliant strobe. In 1997, the MASS was replaced by the SpectrAlert series. [citation needed]
Front page of a floppy disk controller data sheet (1979) A datasheet, data sheet, or spec sheet is a document that summarizes the performance and other characteristics of a product, machine, component (e.g., an electronic component), material, subsystem (e.g., a power supply), or software in sufficient detail that allows a buyer to understand what the product is and a design engineer to ...
Surface acoustic wave sensors are a class of microelectromechanical systems (MEMS) which rely on the modulation of surface acoustic waves to sense a physical phenomenon. The sensor transduces an input electrical signal into a mechanical wave which, unlike an electrical signal, can be easily influenced by physical phenomena.
A data acquisition system is a collection of software and hardware that allows one to measure or control the physical characteristics of something in the real world. A complete data acquisition system consists of DAQ hardware, sensors and actuators, signal conditioning hardware, and a computer running DAQ software.
An output signal switching device (OSSD) is an electronic device used as part of the safety system of a machine. It provides a coded signal which, when interrupted due to a safety event, signals the machine to shut down. It works by converting the standard direct current supply, usually 24 volts, into two pulsed and out-of-phase signals.
The controller performs tasks, processes data and controls the functionality of other components in the sensor node. While the most common controller is a microcontroller, other alternatives that can be used as a controller are: a general purpose desktop microprocessor, digital signal processors, FPGAs and ASICs.
G – get sensor configuration; S – set sensor configuration; are used to find and configure sensor units utilizing the SSI-protocol. The group of commands: R – request sensor data; V – data response; D – data response with status field; are used to read sensor data infrequently. For data streaming purposes defined commands are: