Search results
Results From The WOW.Com Content Network
Wired communication refers to the transmission of data over a wire-based communication technology (telecommunication cables). Wired communication is also known as wireline communication . Examples include telephone networks , cable television or internet access , and fiber-optic communication .
Jabbering ports are partitioned off the network until a carrier is no longer detected. [63] End nodes utilizing a MAC layer will usually detect an oversized Ethernet frame and cease receiving. A bridge/switch will not forward the frame. [64] A non-uniform frame size configuration in the network using jumbo frames may be detected as jabber by ...
The network controller implements the electronic circuitry required to communicate using a specific physical layer and data link layer standard such as Ethernet or Wi-Fi. [a] This provides a base for a full network protocol stack, allowing communication among computers on the same local area network (LAN) and large-scale network communications through routable protocols, such as Internet ...
3Com 3C905B-TX 100BASE-TX PCI network interface card 100BASE-TX is the predominant form of Fast Ethernet, and runs over two pairs of wire inside a Category 5 or above cable. Cable distance between nodes can be up to 100 metres (328 ft).
Also shown in this example (shaded in yellow) is the network's connection to the Internet via fixed-line means. A local area network (LAN) is a computer network that interconnects computers within a limited area such as a residence, campus, or building, [1] [2] [3] and has its network equipment and interconnects locally managed. LANs facilitate ...
The most common network type in which backhaul is implemented is a mobile network. A backhaul of a mobile network, also referred to as a mobile-backhaul connects a cell site towards the core network. The two main methods of mobile backhaul implementations are fiber-based backhaul and wireless point-to-point backhaul. [2]
In telecommunications, a network-to-network interface (NNI) is an interface that specifies signaling and management functions between two networks. An NNI circuit can be used for interconnection of signalling (e.g., SS7 ), Internet Protocol (IP) (e.g., MPLS ) or ATM networks.
A simple electric circuit made up of a voltage source and a resistor. Here, =, according to Ohm's law. An electrical network is an interconnection of electrical components (e.g., batteries, resistors, inductors, capacitors, switches, transistors) or a model of such an interconnection, consisting of electrical elements (e.g., voltage sources, current sources, resistances, inductances ...