When.com Web Search

  1. Ads

    related to: 1 2 pipe insulation tubes

Search results

  1. Results From The WOW.Com Content Network
  2. Pipe insulation - Wikipedia

    en.wikipedia.org/wiki/Pipe_insulation

    For this reason, it is more common to use the thermal conductivity value when comparing the effectiveness of pipe insulation, and R-values of pipe insulation are not covered by the US FTC R-value rule Archived 2007-12-31 at the Wayback Machine. The thermal resistance of each insulation layer is calculated using the following equation:

  3. Shell-and-tube heat exchanger - Wikipedia

    en.wikipedia.org/wiki/Shell-and-tube_heat_exchanger

    Most shell-and-tube heat exchangers are either 1, 2, or 4 pass designs on the tube side. This refers to the number of times the fluid in the tubes passes through the fluid in the shell. In a single pass heat exchanger, the fluid goes in one end of each tube and out the other.

  4. Insulated pipe - Wikipedia

    en.wikipedia.org/wiki/Insulated_pipe

    Both standards require use of polyurethane foam for thermal insulation and HDPE for casing. Insulated pipelines are usually assembled from pipes of 6 metres (20 ft), 12 metres (39 ft), or 16 metres (52 ft) in length, directly buried in soil in depths of commonly 0.6–1.2 metres (2 ft 0 in – 3 ft 11 in).

  5. Cross-linked polyethylene - Wikipedia

    en.wikipedia.org/wiki/Cross-linked_polyethylene

    A cross-linked polyethylene (PEX) pipe. Cross-linked polyethylene, commonly abbreviated PEX, XPE or XLPE, is a form of polyethylene with cross-links.It is used predominantly in building services pipework systems, hydronic radiant heating and cooling systems, domestic water piping, insulation for high tension (high voltage) electrical cables, and baby play mats.

  6. Heat-shrink tubing - Wikipedia

    en.wikipedia.org/wiki/Heat-shrink_tubing

    Polyolefin heat-shrink tubing typically shrinks 2:1 diametrically, [10] [9] but high-grade polyolefin heat-shrink is also available with a 3:1 ratio. [7] Polyolefin tubing may withstand being touched with a soldering iron. [10] PVC tubes are usually lower cost than other materials. [1]

  7. Copper tubing - Wikipedia

    en.wikipedia.org/wiki/Copper_tubing

    While pipe sizes in Australia are inch-based, they are classified by outside rather than inside diameter (e.g., a nominal 3 ⁄ 4 inch copper pipe in Australia has measured diameters of 0.750 inches outside and 0.638 inches inside, whereas a nominal 3 ⁄ 4 inch copper pipe in the U.S. and Canada has measured diameters of 0.875 inch outside and ...

  1. Ads

    related to: 1 2 pipe insulation tubes