Search results
Results From The WOW.Com Content Network
The Colt Paterson revolver was the first commercial repeating firearm employing a revolving cylinder with multiple chambers aligned with a single, stationary barrel. Its design was patented by Samuel Colt on February 25, 1836, in the United States, England and France, and it derived its name from being produced in Paterson, New Jersey .
Smith & Wesson Model 1 Third Issue open. The tip-up revolver was the first design to be used with metallic cartridges in the Smith & Wesson Model 1, on which the barrel pivoted upwards, hinged on the forward end of the topstrap. On the S&W tip-up revolvers, the barrel release catch is located on both sides of the frame in front of the trigger.
The first revolving-breech pistols made at the factory were named "Whitneyville-Hartford-Dragoons" and became so popular that the word "Colt" was often used as a generic term for "revolver". [32] The Whitneyville-Hartford Dragoon, largely built from leftover Walker parts, is known as the first model in the transition from the Walker to the ...
The Smith & Wesson Model 1 was the first firearm manufactured by Smith & Wesson, with production spanning from 1857 to 1882. It was the first commercially successful revolver to use rimfire cartridges instead of loose powder, musket ball, and percussion caps. It is a single-action, tip-up revolver holding seven .22 Short black powder cartridges ...
The first of these conversions was patented on September 15, 1868, by Colt engineer, F. Alexander Thuer as patent number 82258. The Thuer conversion was made by milling off the rear of the receiver and replacing it with a breechplate containing six internal firing pins. The cartridges were loaded through the mouths of the chambers.
Colt was the first manufacturer to produce a revolver with a swing-out cylinder. Smith & Wesson followed seven years later with the Hand Ejector, Model 1896 in .32 S&W Long caliber. This was an improvement over the Colt 1889 design since it used a combined center-pin and ejector rod to lock the cylinder in position.
The M1854 model was a single-action, pinfire revolver holding six rounds. [1] It was a French military revolver chambered for the 12 mm pinfire cartridge, based on a design by Casimir Lefaucheux (Eugene's father, who was also a gun designer). The M1854 revolver spawned numerous variants, some of which were produced under license in other countries.
It has been in production since 1965, and was the first regular production all stainless steel firearm made. [1] The 1965 model's stainless steel production proved so popular that there was a waiting list at gunshops for up to six months to purchase one. At that time the Model 60 featured a 1.875" barrel and was chambered solely for the .38 ...