Ads
related to: oxygen tank for cutting torch
Search results
Results From The WOW.Com Content Network
The oxygen flow rate is critical; too little will make a slow ragged cut, while too much will waste oxygen and produce a wide concave cut. Oxygen lances and other custom made torches do not have a separate pressure control for the cutting oxygen, so the cutting oxygen pressure must be controlled using the oxygen regulator.
A set of MAPP and oxygen cylinders is used for oxy-fuel welding and cutting.. MAPP gas was a trademarked name, belonging to The Linde Group, a division of the former global chemical giant Union Carbide, for a fuel gas based on a stabilized mixture of methylacetylene (propyne), propadiene and propane.
A thermal lance, thermic lance, oxygen lance, or burning bar is a tool that heats and melts steel in the presence of pressurized oxygen to create very high temperatures for cutting. It consists of a long steel tube packed with alloy steel rods, which serve as fuel; these are sometimes mixed with aluminum rods to increase the heat output.
An oxygen tank is an oxygen storage vessel, ... oxyacetylene welding equipment, glass lampworking torches, and some gas cutting torches, usually in high pressure ...
Oxyhydrogen is a mixture of hydrogen (H 2) and oxygen (O 2) gases. This gaseous mixture is used for torches to process refractory materials and was the first [1] gaseous mixture used for welding. Theoretically, a ratio of 2:1 hydrogen:oxygen is enough to achieve maximum efficiency; in practice a ratio 4:1 or 5:1 is needed to avoid an oxidizing ...
Depending on the application they are also often used at the torch side as an additional safety device. Flashback arrestors help prevent: Further gas flow in the case of pressure shocks. The entry of air or oxygen into the distribution line or single cylinders. Flashbacks which are the rapid propagation of a flame down the hose.
Ad
related to: oxygen tank for cutting torch