Ads
related to: pipe casing spacer details diagram
Search results
Results From The WOW.Com Content Network
Casing Diameters of a Borehole Casing Diagram premium gas tight connections on a casing string. Casing is a large diameter pipe that is assembled and inserted into a recently drilled section of a borehole. Similar to the bones of a spine protecting the spinal cord, casing is set inside the drilled borehole to protect and support the wellstream.
Used natural gas line pipe is also used as casing on many projects because it is often reclaimed in very good condition and can offer a significant cost savings when compared to new steel pipe. Used pipe is most likely to not have any testing data associated with it and is generally used when the only required specification is a given diameter ...
Drill pipe (#16) is a joint of hollow tubing used to connect the surface equipment to the bottom hole assembly (BHA) and acts as a conduit for the drilling fluid. In the diagram, these are stands of drill pipe which are 2 or 3 joints of drill pipe connected and stood in the derrick vertically, usually to save time while tripping pipe.
Production casing is cemented through the zone and the pay section is selectively perforated. Gas and water are easily controlled as is sand. The formation can be selectively stimulated and the well can be deepened. This selection is adaptable to other completion configurations and logs are available to assist casing decisions.
Provides a means of tubing suspension (Tubing is removable pipe installed in the well through which well fluids pass). Provides a means of pressure sealing and isolation between casing at surface when many casing strings are used. Provides pressure monitoring and pumping access to annuli between the different casing/tubing strings.
A liner is a casing string that does not extend to the surface, being hung instead from a liner hanger set inside of the previous casing string but usually within about 300 feet (91 m) of its bottom. Other than the obvious cost savings, the liner installation allows larger drill pipe or production tubing to be used in the upper portions of the ...
Tubing is a smaller diameter pipe that is run inside of the production casing. A packer is usually set at the lower end of the casing to prevent formation fluid from entering the annulus between the tubing and the casing. A packer is an elastomer cylinder that forms a pressure seal between the tubing and the casing.
Casing hangers must be designed to take the full weight of the casing, and provide a seal between the casing hanger and the spool. Casing Hangers may also be suspended within the wellhead by means of radial distortion of the wellhead bore e.g. the "Pos-Grip" method. This is installed to support the individual casing strings in the well.