Search results
Results From The WOW.Com Content Network
The Penman equation describes evaporation (E) from an open water surface, and was developed by Howard Penman in 1948. Penman's equation requires daily mean temperature, wind speed, air pressure, and solar radiation to predict E. Simpler Hydrometeorological equations continue to be used where obtaining such data is impractical, to give comparable results within specific contexts, e.g. humid vs ...
E = Mass water evapotranspiration rate (g s −1 m −2) ET = Water volume evapotranspired (mm s −1) Δ = Rate of change of saturation specific humidity with air temperature. (Pa K −1) R n = Net irradiance (W m −2), the external source of energy flux G = Ground heat flux (W m −2), usually difficult to measure
Given the limited data input to the equation, the calculated evapotranspiration should be regarded as only broadly accurate. Rather than a precise measure of evapotranspiration, the output of the equation is better thought of as providing an order of magnitude. [2] The inaccuracy of the equation is exacerbated by extreme variants of weather.
Monthly estimated potential evapotranspiration and measured pan evaporation for two locations in Hawaii, Hilo and Pahala. Potential evapotranspiration is usually measured indirectly, from other climatic factors, but also depends on the surface type, such as free water (for lakes and oceans), the soil type for bare soil, and also the density and diversity of vegetation.
Pan evaporation is a measurement that combines or integrates the effects of several climate elements: temperature, humidity, rain fall, drought dispersion, solar radiation, and wind. Evaporation is greatest on hot, windy, dry, sunny days; and is greatly reduced when clouds block the sun and when air is cool, calm, and humid. [ 1 ]
Inputs to SPEI datasets can include high-resolution potential evapotranspiration (PET) from the Global Land Evaporation Amsterdam Model (GLEAM) and hourly Potential Evapotranspiration (hPET). GLEAM is a set of algorithms designed to calculate actual evaporation, PET, evaporative stress, and root-zone soil moisture. [5]
Rate of transpiration can be influenced by factors including plant type, soil type, weather conditions and water content, and also cultivation practices. [6]: Ch. 1, "Transpiration" Evapotranspiration is typically measured in millimeters of water (i.e. volume of water moved per unit area of the Earth's surface) in a set unit of time. [6]:
The single probe method employs a heat source inserted into the soil whereby heat energy is applied continuously at a given rate. The thermal properties of the soil can be determined by analysing the temperature response adjacent to the heat source via a thermal sensor. This method reflects the rate at which heat is conducted away from the probe.