Search results
Results From The WOW.Com Content Network
Experimental broadcasts using the first three prototype versions of the UEIT (one of which was a modification of the Hungarian HTV TR.0782 test card; [9] but all were collectively referred to as UEIT-1) began from the Ostankino Tower transmitter in 1970, with results being used to create the current version of the test pattern.
Voltage is applied to the MOS structure to force a controlled current through the oxide, i.e. to inject a controlled amount of charge into the dielectric layer. By measuring the time after which the measured voltage drops towards zero (when electrical breakdown occurs) and integrating the injected current over time, the charge needed to break the gate oxide is determined.
An LCR meter is a type of electronic test equipment used to measure the inductance (L), capacitance (C), and resistance (R) of an electronic component. [1] In the simpler versions of this instrument the impedance was measured internally and converted for display to the corresponding capacitance or inductance value. Readings should be reasonably ...
Measuring ESR can be done by applying an alternating voltage at a frequency at which the capacitor's reactance is negligible, in a voltage divider configuration. It is easy to check ESR well enough for troubleshooting by using an improvised ESR meter comprising a simple square-wave generator and oscilloscope, or a sinewave generator of a few tens of kilohertz and an AC voltmeter, using a known ...
Musical Fidelity was founded in 1982 by Antony Michaelson, a clarinettist and Hi-Fi enthusiast, following his exit from Michaelson & Austin, a predecessor company of which he was a partner. Musical Fidelity's first product was "The Preamp", which incorporated moving coil and moving magnet pre-amplification and a single line-level ‘Tuner’ input.
A common form of in-circuit testing uses a bed-of-nails tester.This is a fixture that uses an array of spring-loaded pins known as "pogo pins". When a printed circuit board is aligned with and pressed down onto the bed-of-nails tester, the pins make electrical contact with locations on the circuit board, allowing them to be used as test points for in-circuit testing.
About 1/8 wavelength long: (left) 200 MHz stub is 19 cm, (right) 300 MHz stub is 12.5 cm 10 kW FM broadcast transmitter from 1947 showing quarter-wave resonant stub plate tank circuit. In microwave and radio-frequency engineering, a stub or resonant stub is a length of transmission line or waveguide that is connected at one end only. The free ...
From 1 March 1975, the Dutch public broadcasting system also started to use the Philips circle pattern on its TV channels, replacing the monochrome RMA 1946 Resolution Chart, the electronic monochrome chequerboard test card generated by a Philips GM 2671/50 video signal generator, [141] the Philips PM5552 early colour test card, and after the ...