Ad
related to: plaster of paris preparation equation
Search results
Results From The WOW.Com Content Network
With judicious heating, gypsum converts to the partially dehydrated mineral called bassanite or plaster of Paris. This material has the formula CaSO 4 ·( n H 2 O), where 0.5 ≤ n ≤ 0.8. [ 8 ] Temperatures between 100 and 150 °C (212–302 °F) are required to drive off the water within its structure.
The word gypsum is derived from the Greek word γύψος (gypsos), "plaster". [9] Because the quarries of the Montmartre district of Paris have long furnished burnt gypsum (calcined gypsum) used for various purposes, this dehydrated gypsum became known as plaster of Paris. Upon adding water, after a few dozen minutes, plaster of Paris becomes ...
Plaster of Paris is produced by dehydration of gypsum in a kiln: [10] [11] + heat + (released as steam). The resulting dry powder is ready to be mixed with water to form a stiff but workable paste that hardens.
Plaster is widely used as a support for broken bones; a bandage impregnated with plaster is moistened and then wrapped around the damaged limb, setting into a close-fitting yet easily removed tube, known as an orthopedic cast. Plaster is also used in preparation for radiotherapy when fabricating individualized immobilization shells for patients ...
There are several different filler materials used in ceramics including plaster of Paris and other commercially available putties and fillers. Plaster of Paris is a material that consists of calcium sulphate hemihydrate power and is produced by heating gypsum to 120 °C.
Gypsum mortar, also called plaster of Paris, was used in the construction of many ancient structures. It is made from gypsum, which requires a lower firing temperature. It is therefore easier to make than lime mortar and sets up much faster, which may be a reason it was used as the typical mortar in ancient, brick arch and vault construction.
It is chiefly made of plaster of Paris (powdered gypsum), with a little cement, glycerin, and dextrin, mixed with water until it is about as thick as molasses. When staff is cast in molds, it can form any shape. To strengthen it, coarse cloth or bagging, or fibers of hemp or jute, are put into the molds before casting. It becomes hard enough in ...
The plaster is not pure plaster of Paris, but rather has additives to improve green strength, dry strength, permeability, and castability.For instance, talc or magnesium oxide are added to prevent cracking and reduce setting time; lime and cement limit expansion during baking; glass fibers increase strength; sand can be used as a filler. [1]