Ads
related to: building code for plumbing vents and drain pipe
Search results
Results From The WOW.Com Content Network
Under many older building codes, a vent stack (a pipe leading to the main roof vent) is required to be within approx. a 5-foot (1.5 m) radius of the draining fixture it serves (sink, toilet, shower stall, etc.). [2]
The committee worked with the National Bureau of Standards until 1933, when funding was curtailed. In 1921 the Building Code Committee and in 1925 a report was issued titled "Recommended Practice for Arrangement of Building Codes" which consisted of 19 chapters, including Chapter 15 on plumbing. This report was known informally as the "Hoover ...
This code is also used as the basis for the plumbing codes of some other countries. Another model plumbing code published and utilized widely across the United States is the Uniform Plumbing Code , published by the International Association of Plumbing and Mechanical Officials ( IAPMO ), a multinational operation with offices in 13 nations.
The IPC is the most widely used plumbing code in the United States and is also used as the basis for the plumbing code of several other countries [citation needed].Wide adoptions are important as they help reduce manufacturer and end-user costs by allowing the use of materials across a wide user base, thus allowing economies of scale in the production of materials used in construction.
In the United States, plumbing codes usually provide strict limitations on how far a trap may be located from the nearest vent stack. When a vent cannot be provided, an air admittance valve may be used instead. These devices avoid negative pressure in the drain pipe by venting room air into the drain pipe (behind the trap).
The founding members of IAPMO first gathered to begin writing a model code to protect the health of the people they served from inept plumbing practices. There were 39 Southern California plumbing inspectors in the first group, including Charles Collard, the association's first president, and Stephen Smoot, who served as association secretary ...
Due to its toxicity, most cities moved away from lead water-supply piping by the 1920s in the United States, [36] although lead pipes were approved by national plumbing codes into the 1980s, [37] and lead was used in plumbing solder for drinking water until it was banned in 1986. [36] Drain and vent lines are made of plastic, steel, cast iron ...
A plumbing drawing, a type of technical drawing, shows the system of piping for fresh water going into the building and waste going out, both solid and liquid. It also includes fuel gas drawings. Mainly plumbing drawing consist of water supply system drawings, drainage system drawings, irrigation system drawings, storm water system drawings.