Search results
Results From The WOW.Com Content Network
The amount of energy that is returned to the radar receiver is a function of the peak energy of the pulse, the pulse width, and the pulse repetition frequency. Increasing the pulse width increases the amount of energy reflected off the target and thereby increases the range at which an object can be detected.
(For simplicity, all further discussion will use metric figures.) If the radar pulse width is 1 μs, then there can be no detection of targets closer than about 150 m, because the receiver is blanked. All this means that the designer cannot simply increase the pulse width to get greater range without having an impact on other performance factors.
Pulse-width modulation (PWM), also known as pulse-duration modulation (PDM) or pulse-length modulation (PLM), [1] is any method of representing a signal as a rectangular wave with a varying duty cycle (and for some methods also a varying period). PWM is useful for controlling the average power or amplitude delivered by an electrical signal.
The Rayleigh bandwidth of a simple radar pulse is defined as the inverse of its duration. For example, a one-microsecond pulse has a Rayleigh bandwidth of one megahertz. [1] The essential bandwidth is defined as the portion of a signal spectrum in the frequency domain which contains most of the energy of the signal. [2]
Servo and receiver connections A diagram showing typical PWM timing for a servomotor. Servo control is a method of controlling many types of RC/hobbyist servos by sending the servo a PWM (pulse-width modulation) signal, a series of repeating pulses of variable width where either the width of the pulse (most common modern hobby servos) or the duty cycle of a pulse train (less common today ...
In a distribution, full width at half maximum (FWHM) is the difference between the two values of the independent variable at which the dependent variable is equal to half of its maximum value. In other words, it is the width of a spectrum curve measured between those points on the y -axis which are half the maximum amplitude.
Modern radar systems are generally able to smoothly change their PRF, pulse width and carrier frequency, making identification much more difficult. Sonar and lidar systems also have PRFs, as does any pulsed system. In the case of sonar, the term pulse-repetition rate (PRR) is more common, although it refers to the same concept.
For a chirp waveform that sweeps over a frequency range F1 to F2 in a time period T, the nominal bandwidth of the pulse is B, where B = F2 – F1, and the pulse has a time-bandwidth product of T×B. Following pulse compression, a narrow pulse of duration τ is obtained, where τ ≈ 1/B, together with a peak voltage amplification of √ T×B.