Search results
Results From The WOW.Com Content Network
Will change OperandSize from 16-bit to 32-bit if CS.D=0, or from 32-bit to 16-bit if CS.D=1. 67h: AddressSize override. Will change AddressSize from 16-bit to 32-bit if CS.D=0, or from 32-bit to 16-bit if CS.D=1. The 80386 also introduced the two new segment registers FS and GS as well as the x86 control, debug and test registers.
INT is an assembly language instruction for x86 processors that generates a software interrupt. It takes the interrupt number formatted as a byte value. [1] When written in assembly language, the instruction is written like this: INT X. where X is the software interrupt that should be generated (0-255).
The descriptors may be either interrupt gates, trap gates or, for 32-bit protected mode only, task gates. Interrupt and trap gates point to a memory location containing code to execute by specifying both a segment (present in either the GDT or LDT) and an offset within that segment. The only difference between trap and interrupt gates is that ...
Ralf Brown's Interrupt List (aka RBIL, x86 Interrupt List, MS-DOS Interrupt List or INTER) is a comprehensive list of interrupts, calls, hooks, interfaces, data structures, CMOS settings, memory and port addresses, as well as processor opcodes for x86 machines from the 1981 IBM PC up to 2000 (including many clones), [1] [2] [nb 1] most of it still applying to IBM PC compatibles today.
A general protection fault (GPF) in the x86 instruction set architectures (ISAs) is a fault (a type of interrupt) initiated by ISA-defined protection mechanisms in response to an access violation caused by some running code, either in the kernel or a user program.
Also, importantly, address offsets are 32-bit (instead of 16-bit), and the segment base in each segment descriptor is also 32-bit (instead of 24-bit). The general operation of the segmentation unit is otherwise unchanged. The paging unit may be enabled or disabled; if disabled, operation is the same as on the 80286.
The Intel 8086 and subsequent processors in the x86 series have an HLT (halt) instruction, opcode F4, which stops instruction execution and places the processor in a HALT state. An enabled interrupt, a debug exception, the BINIT signal, the INIT signal, or the RESET signal resumes execution, which means the processor can always be restarted. [15]
On the x86 architecture, a double fault exception occurs if the processor encounters a problem while trying to service a pending interrupt or exception.An example situation when a double fault would occur is when an interrupt is triggered but the segment in which the interrupt handler resides is invalid.