Ad
related to: split ethernet cable into two devices windows 10 driver update keeps popping up
Search results
Results From The WOW.Com Content Network
Multi-link trunking (MLT) is a link aggregation technology developed at Nortel in 1999. It allows grouping several physical Ethernet links into one logical Ethernet link to provide fault-tolerance and high-speed links between routers, switches, and servers.
Link aggregation offers an inexpensive way to set up a high-capacity backbone network that transfers multiple times more data than any single port or device can deliver. Link aggregation also allows the network's backbone speed to grow incrementally as demand on the network increases, without having to replace everything and deploy new hardware.
An Ethernet crossover cable is a crossover cable for Ethernet used to connect computing devices together directly. It is most often used to connect two devices of the same type, e.g. two computers (via their network interface controllers ) or two switches to each other.
The X refers to the fact that transmit wires on an MDI device must be connected to receive wires on an MDI-X device. Straight-through cables connect pins 1 and 2 (transmit) on an MDI device to pins 1 and 2 (receive) on an MDI-X device. Similarly, pins 3 and 6 are receive pins on an MDI device and transmit pins on an MDI-X device.
On an Ethernet connection, a duplex mismatch is a condition where two connected devices operate in different duplex modes, that is, one operates in half duplex while the other one operates in full duplex. The effect of a duplex mismatch is a link that operates inefficiently.
The two Ethernet interfaces of a node use the same MAC address. This is allowed since the two LANs have no connection. Therefore, PRP is a layer 2 redundancy, which allows higher layer network protocols to operate without modification. A PRP node needs only one IP address. Especially, the ARP protocol will correctly relate the MAC to the IP ...
Routing allows multiple networks to communicate independently and yet remain separate, whereas bridging connects two separate networks as if they were a single network. [2] In the OSI model, bridging is performed in the data link layer (layer 2). [3] If one or more segments of the bridged network are wireless, the device is known as a wireless ...
Ethernet devices must allow a minimum idle period between transmission of Ethernet packets. [1] A brief recovery time between packets allows devices to prepare for reception of the next packet. While some physical layer variants literally transmit nothing during the idle period, most modern ones continue to transmit an idle pattern signal.