Ads
related to: 348 master engine rebuild kit 4 6 l belt routing diagram
Search results
Results From The WOW.Com Content Network
This engine was superseded by the 409 cu in (6.7 L) as Chevrolet's top performing engine in 1961 and went out of production for cars at the end of that year. It was produced through 1964 for use in large Chevrolet trucks. 1958 348 4-barrel engine. With a four-barrel carburetor, the base Turbo-Thrust produced 250 hp (186 kW).
The Chevrolet Stovebolt engine is a straight-six engine made in two versions between 1929 and 1962 by the Chevrolet Division of General Motors.It replaced the company's 171-cubic-inch (2.8 L) inline-four as their sole engine offering from 1929 through 1954, and was the company's base engine starting in 1955 when it added the small block V8 to the lineup.
The medium-duty 1930 A-series trucks received the all-new 278.7 cu in (4.6 L) FB-3 six-cylinder engine, with overhead valves and seven main bearings. This was complemented by larger versions of the same engine and was built until late 1940 (as the FBB), [ 7 ] the line-up being expanded downward by the smaller FA-series (later FAB) in 1933.
The big-block engines initially used a forged crankshaft with a stroke of 3.975" for the 1965-1967 425 and 400 CID versions; starting in 1968, both the 400 cu in (6.6 L) and the 455 cu in (7.5 L) big blocks used a stroke of 4.25 in (108 mm), with crankshaft material changed to cast iron except in a few rare cases.
The 400 cu in (6.6 L) B engine was introduced in 1972 to replace the venerable 383, and were power-rated via the net (installed) method. Chrysler increased the bore size of the 383 to create the 400. Its bore of 4.342-inch (110.3 mm) was the largest used in any production Chrysler V8 at the date of its introduction.
Although it had had a larger displacement than its 261-cubic-inch (4.3 L) Stovebolt predecessor it was approximately 2 inches (51 mm) shorter and 1 ⁄ 4 inch (6.4 mm) lower. [54] Flywheel bolt pattern is the same as the six and V8, with 1 ⁄ 2 inch (12.7 mm) bolts for the flywheel if produced after the 1966 model year.
The AMX 390 engine in a 1968 AMX. The 390 cu in (6.4 L) AMX engine had a bore and stroke of 4.165 in × 3.574 in (105.8 mm × 90.8 mm). It received heavier main bearing support webbing than the smaller AMC V8s, as well as a forged steel crankshaft and connecting rods. Forged cranks and rods were used for their known strength—there was ...
The 430 was replaced by the 462 cu in (7.6 L; 7,565 cc) engine in 1966. Bore and stroke were entirely different at 4.38 and 3.83 inches (111.3 and 97.3 mm) and the 462 MEL engine produced 340 hp (254 kW) and as much as 485 lb⋅ft (658 N⋅m) of torque. This engine was fitted with hydraulic lifters and a four-barrel Carter AFB carburetor.