When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Self-tapping screw - Wikipedia

   en.wikipedia.org/wiki/Self-tapping_screw

   A self-tapping screw is a screw that can tap its own hole as it is driven into the material. More narrowly, self-tapping is used only to describe a specific type of thread-cutting screw intended to produce a thread in relatively soft material or sheet materials, excluding wood screws .

3. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   self-tapping machine screw: A self-tapping machine screw is similar to a machine screw, except the lower part of the shank is designed to cut threads as the screw is driven into an untapped hole. The advantage of this screw type over a self-drilling screw is that, if the screw is reinstalled, new threads are not cut as the screw is driven. set bolt

4. Positive locking device - Wikipedia

   en.wikipedia.org/wiki/Positive_locking_device

   These practices are not a means of obtaining or maintaining torque, rather a safety device to prevent the disengagement of screws, nuts, bolts, snap rings, oil caps, drain cocks, valves, and parts. Three basic methods are used in safetying; safety-wire, cotter pins, and self-locking nuts. Retainer washers and pal nuts are also sometimes used. [2]

5. Screw - Wikipedia

   en.wikipedia.org/wiki/Screw

   A machine screw or bolt is usually a smaller fastener (less than 1 ⁄ 4 inch (6.35 mm) in diameter) threaded the entire length of its shank that usually has a recessed drive type (slotted, Phillips, etc.), usually intended to screw into a pre-formed thread, either a nut or a threaded (tapped) hole, unlike a wood or self-tapping screw. Machine ...

6. Washer (hardware) - Wikipedia

   en.wikipedia.org/wiki/Washer_(hardware)

   Spherical washer nut and screw Part of a self-aligning nut; it is a washer with one radiused surface, which is designed to be used in conjunction with a mating nut in order to allow for up to several degrees of misalignment between parts. [4] Anchor plate or wall washer A large plate or washer connected to a tie rod or bolt.

7. Captive fastener - Wikipedia

   en.wikipedia.org/wiki/Captive_fastener

   E-Ring makes the fastener captive on this battery compartment screw captive screw on a Selfie stick E-Ring on the bold of a camera belt. A captive fasteners is an engineered fastener designed for a permanent hold within a target assembly or housing, including upon servicing. They provide a secure joining, and avoid fastener loss or damage that ...