Ads
related to: cisco packet tracer manualusermanualsonline.com has been visited by 100K+ users in the past month
Search results
Results From The WOW.Com Content Network
Packet Tracer is a cross-platform visual simulation tool designed by Cisco Systems that allows users to create network topologies and imitate modern computer networks. The software allows users to simulate the configuration of Cisco routers and switches using a simulated command line interface.
Cisco's implementation of traceroute also uses a sequence of UDP datagrams, each with incrementing TTL values, to an invalid port number at the remote host; by default, UDP port 33434 is used. An extended version of this command (known as the extended traceroute command) can change the destination port number used by the UDP probe messages.
The Dynamic Trunking Protocol (DTP) is a proprietary link layer protocol developed by Cisco Systems for the purpose of negotiating trunking on a link between two VLAN-aware switches, and for negotiating the type of trunking encapsulation to be used. VLAN trunks formed using DTP may utilize either IEEE 802.1Q or Cisco ISL trunking protocols. [1]
metric: The routing metric of the path through which the packet is to be sent. The route will go in the direction of the gateway with the lowest metric. next hop: The next hop, or gateway, is the address of the next station to which the packet is to be sent on the way to its final destination
Cisco had already issued a patch, but asked that the flaw not be disclosed. [18] Cisco filed a lawsuit, but settled after an injunction was issued to prevent further disclosures. [19] With IOS being phased out on devices, IOS-XE adopted many improvements including updated defaults. Some use cases can now store secrets as one-way hashes.
Then, similar to IPv4, any device along the path whose MTU is smaller than the packet will drop the packet and send back an ICMPv6 Packet Too Big (Type 2) message containing its MTU, allowing the source host to reduce its path MTU appropriately. The process is repeated until the MTU is small enough to traverse the entire path without fragmentation.
Open Shortest Path First (OSPF) is a routing protocol for Internet Protocol (IP) networks. It uses a link state routing (LSR) algorithm and falls into the group of interior gateway protocols (IGPs), operating within a single autonomous system (AS).
In telecommunication networks, packet switching is used to optimize the usage of channel capacity and increase robustness. [59] Compared to circuit switching, packet switching is highly dynamic, allocating channel capacity based on usage instead of explicit reservations. This can reduce wasted capacity caused by underutilized reservations at ...
Ad
related to: cisco packet tracer manualinfosecinstitute.com has been visited by 10K+ users in the past month