Search results
Results From The WOW.Com Content Network
The traffic channels with the same HSN hop over the same frequencies in the same order but are separated in time by a mobile allocation index offset (MAIO). [1] [2] The smallest amount of interference on a site is achieved if it is possible to synchronize all channels on the site and separate the channels using the MAIO. [3]
Matching is a statistical technique that evaluates the effect of a treatment by comparing the treated and the non-treated units in an observational study or quasi-experiment (i.e. when the treatment is not randomly assigned).
RIPv1 is not suitable for large networks as it limits the number of hops to 15. This hop limit was introduced to avoid routing loops, but also means that networks that are connected through more than 15 routers are unreachable. [3] The distance-vector protocol designed for use in wide area networks (WANs) is the Border Gateway Protocol (BGP).
An antenna's impedance is different at different frequencies. An antenna tuner matches a radio with a fixed impedance (typically 50 Ohms for modern transceivers) to the combination of the feedline and the antenna; useful when the impedance seen at the input end of the feedline is unknown, complex, or otherwise different from the transceiver.
The routing table contains network/next hop associations. These associations tell a router that a particular destination can be optimally reached by sending the packet to a specific router that represents the next hop on the way to the final destination. The next hop association can also be the outgoing or exit interface to the final destination.
Typical oils used have an index of refraction around 1.515. [2] An oil immersion objective is an objective lens specially designed to be used in this way. The index of the oil is typically chosen to match the index of the microscope lens glass, and of the cover slip. For more details, see the main article, oil immersion.
For example, in order to match an inductive load into a real impedance, a capacitor needs to be used. If the load impedance becomes capacitive, the matching element must be replaced by an inductor. In many cases, there is a need to use the same circuit to match a broad range of load impedance and thus simplify the circuit design.
Longest prefix match (also called Maximum prefix length match) refers to an algorithm used by routers in Internet Protocol (IP) networking to select an entry from a routing table. [ 1 ] Because each entry in a forwarding table may specify a sub-network, one destination address may match more than one forwarding table entry.