Search results
Results From The WOW.Com Content Network
An antenna's impedance is different at different frequencies. An antenna tuner matches a radio with a fixed impedance (typically 50 Ohms for modern transceivers) to the combination of the feedline and the antenna; useful when the impedance seen at the input end of the feedline is unknown, complex, or otherwise different from the transceiver.
For mobile phone technology, a mobile allocation index offset (MAIO) refers a time delay separating traffic channels.When a GSM (Global System for Mobile Communications) mobile phone is served by a cell that is hopping over a set of frequencies, the separate traffic channels hop over the allocated frequencies according to a hopping sequence number (HSN).
The Maidenhead Locator System (a.k.a. QTH Locator and IARU Locator) is a geocode system used by amateur radio operators to succinctly describe their geographic coordinates, which replaced the deprecated QRA locator, which was limited to European contacts. [1]
For example, in order to match an inductive load into a real impedance, a capacitor needs to be used. If the load impedance becomes capacitive, the matching element must be replaced by an inductor. In many cases, there is a need to use the same circuit to match a broad range of load impedance and thus simplify the circuit design.
The routing table contains network/next hop associations. These associations tell a router that a particular destination can be optimally reached by sending the packet to a specific router that represents the next hop on the way to the final destination. The next hop association can also be the outgoing or exit interface to the final destination.
A linear time-invariant system cannot produce intermodulation. If the input of a linear time-invariant system is a signal of a single frequency, then the output is a signal of the same frequency; only the amplitude and phase can differ from the input signal.
Longest prefix match (also called Maximum prefix length match) refers to an algorithm used by routers in Internet Protocol (IP) networking to select an entry from a routing table. [ 1 ] Because each entry in a forwarding table may specify a sub-network, one destination address may match more than one forwarding table entry.
Typical oils used have an index of refraction around 1.515. [2] An oil immersion objective is an objective lens specially designed to be used in this way. The index of the oil is typically chosen to match the index of the microscope lens glass, and of the cover slip. For more details, see the main article, oil immersion.