Search results
Results From The WOW.Com Content Network
ASTM A325 is an ASTM International standard for heavy hex structural bolts, titled Standard Specification for Structural Bolts, Steel, Heat Treated, 120/105 ksi Minimum Tensile Strength. It defines mechanical properties for bolts that range from 1 ⁄ 2 to 1 + 1 ⁄ 2 inches (13 to 38 mm) in diameter. [1]
ASTM A490 and ASTM A490M are ASTM International standards for heavy hex structural bolts made from alloy steel.The imperial standard is officially titled Standard Specification for Structural Bolts, Alloy Steel, Heat Treated, 150 ksi Minimum Tensile Strength, while the metric standard (M) is titled Standard Specification for High-Strength Steel Bolts, Classes 10.9 and 10.9.3, for Structural ...
The standard designation for a UTS thread is a number indicating the nominal (major) diameter of the thread, followed by the pitch measured in threads per inch.For diameters smaller than 1 / 4 inch, the diameter is indicated by an integer number defined in the standard; for all other diameters, the inch figure is given.
Bolt with a nut. A bolt is an externally helical threaded fastener capable of being tightened or released by a twisting force to a matching nut. The bolt has an external male thread requiring a matching nut with a pre-formed female thread. [1]
MSC ADAMS (Automated Dynamic Analysis of Mechanical Systems) is a multibody dynamics simulation software system. It is currently owned by MSC Software Corporation. The simulation software solver runs mainly on Fortran and more recently C++ as well. [1] According to the publisher, Adams is the most widely used multibody dynamics simulation ...
ASTM A354 is an ASTM International standard that defines chemical and mechanical properties for alloy steel bolts, screws, studs, and other externally threaded fasteners.It is officially titled: Standard Specification for Quenched and Tempered Alloy Steel Bolts, Studs, and Other Externally Threaded Fasteners.
It is therefore beneficial in high-frequency high-load situations with a higher risk of fatigue related failure, like a bolted down cylinder head, to use torque to yield bolts. [ citation needed ] The torque applied to the fastener must be determined such that it does not contribute to a service condition where the fastener enters a low-cycle ...
This standard defines property classes, the metric equivalent of a screw grade, that are almost identical to those defined by ISO 898-1, [2] except for the addition of the 8.8.3 and 10.9.3 classes. These two additional standards are fasteners that have the same mechanical properties as their base property class (i.e. 8.8 and 10.9), but are made ...