When.com Web Search

Search results

  1. Results From The WOW.Com Content Network
  2. Bufferbloat - Wikipedia

    en.wikipedia.org/wiki/Bufferbloat

    Bufferbloat can also cause packet delay variation (also known as jitter), as well as reduce the overall network throughput. When a router or switch is configured to use excessively large buffers, even very high-speed networks can become practically unusable for many interactive applications like voice over IP (VoIP), audio streaming , online ...

  3. Network performance - Wikipedia

    en.wikipedia.org/wiki/Network_performance

    Jitter is the undesired deviation from true periodicity of an assumed periodic signal in electronics and telecommunications, often in relation to a reference clock source. Jitter may be observed in characteristics such as the frequency of successive pulses, the signal amplitude , or phase of periodic signals.

  4. Lag (video games) - Wikipedia

    en.wikipedia.org/wiki/Lag_(video_games)

    This usage is a gaming cultural colloquialism and is not commonly found or used in professional computer networking circles. Some factors that might particularly affect ping include: communication protocol used, Internet throughput (connection speed), the quality of a user's Internet service provider and the configuration of firewalls. Ping is ...

  5. Troubleshoot a broadband internet connection - AOL Help

    help.aol.com/articles/troubleshooting-a...

    Check the physical connection - A loose cable or cord can often be the cause of a connection problem. Make sure everything is securely connected to the wall and device. 3. Reboot your modem/router - Sometimes the old "turn it off and on again" approach actually does work! Just wait about five minutes before turning it back on to make sure ...

  6. Jitter - Wikipedia

    en.wikipedia.org/wiki/Jitter

    Jitter period is the interval between two times of maximum effect (or minimum effect) of a signal characteristic that varies regularly with time. Jitter frequency, the more commonly quoted figure, is its inverse. ITU-T G.810 classifies deviation lower frequencies below 10 Hz as wander and higher frequencies at or above 10 Hz as jitter. [2]

  7. Pulse-per-second signal - Wikipedia

    en.wikipedia.org/wiki/Pulse-per-second_signal

    PPS signals are used for precise timekeeping and time measurement. One increasingly common use is in computer timekeeping, including NTP.Because GPS is considered a stratum-0 source, a common use for the PPS signal is to connect it to a PC using a low-latency, low-jitter wire connection and allow a program to synchronize to it.

  8. Troubleshoot a dial-up connection - AOL Help

    help.aol.com/articles/troubleshooting-a-dial-up...

    An active internet connection is required to be able to access all the best that America Online® offers. If you're using dial-up internet and can't connect, try the following troubleshooting steps: Check the dial tone - If you DO have one, it's likely the problem has something to do with your computer. If you DON'T, it's likely the problem has ...

  9. Packet delay variation - Wikipedia

    en.wikipedia.org/wiki/Packet_delay_variation

    In computer networking, packet delay variation (PDV) is the difference in end-to-end one-way delay between selected packets in a flow with any lost packets being ignored. [1] The effect is sometimes referred to as packet jitter , although the definition is an imprecise fit.