Search results
Results From The WOW.Com Content Network
In 3G, the most prevalent technology was UMTS with CDMA-2000 in close contention. All radio access technologies have to solve the same problems: to divide the finite RF spectrum among multiple users as efficiently as possible. GSM uses TDMA and FDMA for user and cell separation. UMTS, IS-95 and CDMA-2000 use CDMA. WiMAX and LTE use OFDM.
To permit this without undue interference between the users, CDMA employs spread spectrum technology and a special coding scheme (where each transmitter is assigned a code). [1] [2] CDMA optimizes the use of available bandwidth as it transmits over the entire frequency range and does not limit the user's frequency range.
IEEE 802.11b wireless local area networks (WLANs) are based on FDMA and DS-CDMA for avoiding interference among adjacent WLAN cells or access points. This is combined with CSMA/CA for multiple access within the cell. HIPERLAN/2 wireless networks combine FDMA with dynamic TDMA, meaning that resource reservation is achieved by packet scheduling.
TDMA frame structure showing a data stream divided into frames and those frames divided into time slots. Time-division multiple access (TDMA) is a channel access method for shared-medium networks. It allows several users to share the same frequency channel by dividing the signal into different time slots. [1]
DAMA and PAMA are related only to channel/resource allocation and should not be confused with the multiple access/multiplexing methods (such as FDMA frequencies, TDMA slots, CDMA codes, or others) intended to divide a single communication channel into multiple virtual channels.
Both EDGE and 1xRTT are 3G standards, as defined by the ITU, but are usually marketed as 2.9G due to their comparatively low speeds and high delays when compared to true 3G technologies. True 3G systems such as EV-DO , W-CDMA (including HSPA and HSPA+ ) provide combined circuit switched and packet switched data and voice services from the ...
In Fixed Channel Allocation or Fixed Channel Assignment (FCA) each cell is given a predetermined set of frequency channels. FCA requires manual frequency planning, which is an arduous task in time-division multiple access (TDMA) and frequency-division multiple access (FDMA) based systems since such systems are highly sensitive to co-channel interference from nearby cells that are reusing the ...
Frequency-division multiple access (FDMA) is a channel access method used in some multiple-access protocols. FDMA allows multiple users to send data through a single communication channel, such as a coaxial cable or microwave beam, by dividing the bandwidth of the channel into separate non-overlapping frequency sub-channels and allocating each sub-channel to a separate user.