Search results
Results From The WOW.Com Content Network
Replacement command Note ifconfig: ip addr, ip link: Address and link configuration route: ip route: Routing tables arp: ip neigh: Neighbors iptunnel: ip tunnel: Tunnels nameif, ifrename: ip link set name: Rename network interfaces ipmaddr: ip maddr: Multicast netstat: ss, ip route: Show various networking statistics brctl: bridge: Handle ...
Local Address – The IP address of the local computer and the port number being used. The name of the local computer that corresponds to the IP address and the name of the port is shown unless the -n parameter is specified. An asterisk (*) is shown for the host if the server is listening on all interfaces.
Then, the command ipconfig /renew is executed to request a new IP address. [ 3 ] [ 4 ] Where a computer is connected to a cable or DSL modem, it may have to be plugged directly into the modem network port to bypass the router, before using ipconfig /release and turning off the power for a period of time, to ensure that the old IP address is ...
COMMAND: The command to run (add, delete, change, get, monitor, flush)-net: <dest> is a network address-host: <dest> is host name or address (default)-netmask: the mask of the route <dest>: IP address or host name of the destination <gateway>: IP address or host name of the next-hop router
On a PC running Windows 10: On the task bar, select WiFi or Ethernet > click on the network you’re currently connected to > select Properties > your IP address is listed next to “IPv4 address.”
Git does periodic repacking automatically, but manual repacking is also possible with the git gc command. [46] For data integrity, both the packfile and its index have an SHA-1 checksum [47] inside, and the file name of the packfile also contains an SHA-1 checksum. To check the integrity of a repository, run the git fsck command. [48] [49]
the command the process is executing; the owner of the process; for all files in use by the process, including the executing text file and the shared libraries it is using: the file descriptor number of the file, if applicable; the file's access mode; the file's lock status; the file's device numbers; the file's inode number; the file's size or ...
Cisco's implementation of traceroute also uses a sequence of UDP datagrams, each with incrementing TTL values, to an invalid port number at the remote host; by default, UDP port 33434 is used. An extended version of this command (known as the extended traceroute command) can change the destination port number used by the UDP probe messages. [13]