Search results
Results From The WOW.Com Content Network
Prior to 1964, tires were all made to a 90% aspect ratio. Tire size was specified as the tire width in inches and the diameter in inches – for example, 6.50-15. [24] From 1965 to the early 1970s, tires were made to an 80% aspect ratio. Tire size was again specified by width in inches and diameter in inches.
ISO 5775 is an international standard for labeling the size of bicycle tires and rims. The system used was originally developed by the European Tyre and Rim Technical Organisation (ETRTO). It is designed to make tire sizing consistent and clear.
Increasing the aspect ratio will increase the height of the tire and hence the circumference. Off-roading tires may use a different measurement scheme: Tread width × Outside diameter, followed by wheel size (all in inches) – for example 31×10.50R15 (787 mm × 267 mm R380 in metric designation). The size of the wheel, however, is denoted as ...
For premium support please call: 800-290-4726 more ways to reach us
You are free: to share – to copy, distribute and transmit the work; to remix – to adapt the work; Under the following conditions: attribution – You must give appropriate credit, provide a link to the license, and indicate if changes were made.
ETRTO sizes apply to rims and tyres for vehicles of all types, including bicycles. The great advantage of ETRTO sizing is that it is unambiguous; previously, nominal dimensions were used which were interpreted in different ways by different countries and manufacturers - a problem for the end user.
Cutaway diagram of a rim and tire from an ATV Cross section of a bicycle rim A wooden bicycle rim with tubular tire The rim is the "outer edge of a wheel, holding the tire". [ 1 ] It makes up the outer circular design of the wheel on which the inside edge of the tire is mounted on vehicles such as automobiles . [ 2 ]
Tire uniformity refers to the dynamic mechanical properties of pneumatic tires as strictly defined by a set of measurement standards and test conditions accepted by global tire and car makers. These standards include the parameters of radial force variation , lateral force variation , conicity, ply steer, radial run-out , lateral run-out , and ...