Search results
Results From The WOW.Com Content Network
An overhead valve engine, abbreviated (OHV) and sometimes called a pushrod engine, is a piston engine whose valves are located in the cylinder head above the combustion chamber. This contrasts with flathead (or "sidevalve") engines , where the valves were located below the combustion chamber in the engine block .
Pushrods are long, slender metal rods that are used in overhead valve engines to transfer motion from the camshaft (located in the engine block) to the valves (located in the cylinder head). The bottom end of a pushrod is fitted with a lifter, upon which the camshaft makes contact. The camshaft lobe moves the lifter upwards, which moves the ...
With lower cylinder blocks, the tappets could drive the valves directly without needing even a push rod. [4] [13] Sidevalve engines also required regular adjustment of the tappet clearance, and in this case it was the tappets themselves that were adjusted directly. Small access plates were provided on the sides of the cylinder block, giving ...
The engine was discontinued in 2003, replaced by the 2.2-liter DOHC Ecotec engine. Although it displaces 134 cu. in, the 2.2-liter OHV is still commonly referred to as the GM 122 today, and has been reputed for its simplicity, reliability, and ease of maintenance in the J-body cars and S-series trucks, and a few L-body cars.
The most common use of a rocker arm is to transfer the motion of a pushrod in an overhead valve (OHV) internal combustion engine to the corresponding intake/exhaust valve. In an OHV engine the camshaft at the bottom of the engine pushes the pushrod upwards. The top of the pushrod presses upwards on one side of the rocker arm located at the top ...
The Toyota K series is an inline-four engine that was produced from 1966 through 2007. It is a two-valve pushrod engine design. It was originally built from the Toyota Kamigo plant in Toyota City factory in Japan. All K series are non-crossflow engines – the inlet and exhaust manifolds are on the same side.
Originally developed in 1959 for the Ford Anglia, it is an in-line four-cylinder overhead valve (OHV) pushrod engine with a cast-iron cylinder head and block. The Kent family can be divided into three basic sub-families; the original pre-Crossflow Kent, the Crossflow (the most prolific of all versions of the Kent), and the transverse mounted ...
The engines were produced in two major variants differing by their piston displacement: a 3.3 L; 201.4 cu in (3,301 cc) and a 3.8 L; 230.5 cu in (3,778 cc). The 3.3 was dropped after 2010 with the Chrysler minivans, and the 3.8 was dropped after 2011 with the Jeep Wrangler, ending 22 years in production.