Ads
related to: 6 inch faucet supply line
Search results
Results From The WOW.Com Content Network
Each fixture usually has a characteristic means of connection. Normal plumbing practice is to install a valve on each water supply line before the fixture, and this is most commonly termed a stop or "service valve". The water supply to some fixtures is cold water only (such as water closets and urinals). Most fixtures also have a hot water supply.
Water cannot flow from the sink to the tap in normal circumstances, even if the water supply loses pressure. An air gap, as related to the plumbing trade, is the unobstructed vertical space between the water outlet and the flood level of a fixture. [1]
Crosses, also known as four-way fittings or cross branch lines, have one inlet and three outlets (or vice versa), and often have a solvent-welded sockets or female-threaded ends. Cross fittings may stress pipes as temperatures change because they are at the center of four connection points.
In plumbing, a Fixture Unit (FU) or Drain Fixture Unit (DFU) is "a unit of measure, based on the rate of discharge, time of operation and frequency of use of a fixture, that expresses the hydraulic load imposed by that fixture on the sanitary plumbing installation". [1]
Designated as an American National Standard, the Uniform Plumbing Code (UPC) is a model code developed by the International Association of Plumbing and Mechanical Officials to govern the installation and inspection of plumbing systems as a means of promoting the public's health, safety and welfare.
Due to its toxicity, most cities moved away from lead water-supply piping by the 1920s in the United States, [36] although lead pipes were approved by national plumbing codes into the 1980s, [37] and lead was used in plumbing solder for drinking water until it was banned in 1986. [36] Drain and vent lines are made of plastic, steel, cast iron ...