Search results
Results From The WOW.Com Content Network
The dry-sump system uses two or more oil pumps and a separate oil reservoir, as opposed to a conventional wet-sump system, which uses only the main sump (U.S.: oil pan) below the engine and a single pump. A dry-sump engine requires a pressure relief valve to regulate negative pressure inside the engine, so internal seals are not inverted.
Dry sump engines in some drag racing cars use scavenging pumps to extract oil and gases from the crankcase. [18] A separator removes the oil, then the gases are fed into the exhaust system via a venturi tube. [citation needed]. This system maintains a small amount of vacuum in the crankcase and minimises the amount of oil in the engine that ...
The Chevrolet small-block engine is a series of gasoline-powered V8 automobile engines, produced by the Chevrolet division of General Motors in two overlapping generations between 1954 and 2003, using the same basic engine block. Referred to as a "small-block" for its size relative to the physically much larger Chevrolet big-block engines, the ...
This design of the engine does not include an oil sump in the crankcase. Four-stroke engines typically have an oil sump at the bottom of the crankcase and the majority of the engine's oil is held within the crankcase. The fuel/air mixture does not pass through the crankcase, though a small amount of exhaust gasses often enter as "blow-by" from ...
During the development process for the 997.2 generation of 911 engines, Porsche built out this engine oil sump rig to test its new integrated sump system. It't a crazy bit of equipment to watch in ...
The Chevrolet Gemini small-block engine is a dual-overhead cam (DOHC) V8 engine designed by General Motors.While technically a small-block engine because of its bore spacing of 4.4 inches, [1] [2] General Motors engineers do not consider it to be a part of the traditional Chevrolet small block lineage because of the substantial reworking, specialized development, and unique technical features ...
It is generally located inside the lower part of the engine, usually below and/or to one side of the crankshaft. On dry sump engines, at least two oil pumps are required: one to pressurize and distribute the oil around the engine components, and at least one other 'scavenge pump' to evacuate the oil which has pooled at the bottom of the engine. [9]
Lubrication is dry sump, and fuelling is via dual CV carburetors or fully redundant electronic fuel injection. The electronic fuel injected Rotax 912iS is a recent development. [5] The 912's lubrication system differs from most dry-sump designs in that oil is forced into the storage tank by crankcase pressure rather than by a separate scavenge ...