Search results
Results From The WOW.Com Content Network
Bloom is a test used to measure the strength of a gel, most commonly gelatin.The test was originally developed and patented in 1925 by Oscar T. Bloom. [1] The test determines the weight in grams needed by a specified plunger (normally with a diameter of 0.5 inch) to depress the surface of the gel by 4 mm without breaking it at a specified temperature. [2]
Gelatin absorbs 5–10 times its weight in water to form a gel. [3] The gel formed by gelatin can be melted by reheating, and it has an increasing viscosity under stress (thixotropic). [3] The upper melting point of gelatin is below human body temperature, a factor that is important for mouthfeel of foods produced with gelatin. [5]
Several different ingredients can be used to form the base of a suppository: cocoa butter or a similar substitute, polyethylene glycol, hydrogels, and glycerinated gelatin. The type of material used depends on the type of suppository, the type of drug, and the conditions in which the suppository will be stored. [4]
[citation needed] It is a common technique used by food industries to determine the pasting temperature, swelling capacity, shear/thermal stability, and the extent of retrogradation. Under controlled conditions, starch and distilled water is heated at a constant heating rate in a rotating bowl and then cooled down.
The melting point of gelatin gel is around 95 °F (35 °C), which is just below normal body temperature (around 97 °F (36 °C)). This is what contributes to the "melt-in-your-mouth" sensation when a marshmallow is consumed—it actually starts to melt when it touches the tongue. [14]
For example, the melting point of silicon at ambient pressure (0.1 MPa) is 1415 °C, but at pressures in excess of 10 GPa it decreases to 1000 °C. [13] Melting points are often used to characterize organic and inorganic compounds and to ascertain their purity. The melting point of a pure substance is always higher and has a smaller range than ...
Triglyceride 3 NaOH / H 2 O Δ 3 × soap 3 × glycerol Triglycerides can be saponified with sodium hydroxide to give glycerol and fatty sodium salt or soap. Typical plant sources include soybeans or palm. Animal-derived tallow is another source. From 2000 to 2004, approximately 950,000 tons per year were produced in the United States and Europe; 350,000 tons of glycerol were produced in the U ...
The Joback method, often named Joback–Reid method, predicts eleven important and commonly used pure component thermodynamic properties from molecular structure only. It is named after Kevin G. Joback in 1984 [1] and developed it further with Robert C. Reid. [2] The Joback method is an extension of the Lydersen method [3] and uses very similar groups, formulas, and parameters for the three ...