Search results
Results From The WOW.Com Content Network
Populated (rear) and unpopulated (front) TSOP land patterns on a printed circuit board. A row of through-holes acting as the footprint for a pin header.. A footprint or land pattern is the arrangement of pads (in surface-mount technology) [1] or through-holes (in through-hole technology) used to physically attach and electrically connect a component to a printed circuit board.
1×6 pin header (one row) 1×6 female header (one row) A pin header (or simply, header) is a form of electrical connector. A male pin header consists of one or more rows of metal pins molded into a plastic base, often 2.54 mm (0.1 in) apart, though available in many spacings. [1] Male pin headers are cost-effective due to their simplicity.
JST manufactures numerous series (families) and pitches (pin-to-pin distance) of connectors. [2] [3] JST connectors are used in many types of products, and commonly used by electronics hobbyists and consumer products for rechargeable battery packs, battery balancers, battery eliminator circuits, 3D printers, and radio controlled servos. [4]
Height of package from pin tip to top of package. T Thickness of pin. L Length of package body only. L W Pin width. L L Pin length from package to pin tip. P Pin pitch (distance between conductors to the PCB). W B Width of the package body only. W L Length from pin tip to pin tip on the opposite side.
Pin-to-pin compatible devices share an assignment of functions to pins, but may have differing electrical characteristics (supply voltages, or oscillator frequencies) or thermal characteristics (TDPs, reflow curves, or temperature tolerances). As a result, their use in a system may require that portions of the system, such as its power delivery ...
Pin 1 is typically indicated on the body of the connector by a red or raised "V" mark. The corresponding wire in a ribbon cable is usually indicated by red coloration, a raised molded ridge, or markings printed onto the cable insulation. On the connector pin 2 is opposite pin 1, pin 3 is next to pin 1 along the length of the connector, and so on.
The size of the Mini Small Outline Package is only 3mm × 3mm for the 8 and 10 pin versions [1] and 3mm × 4mm for the 12 and 16 pin version. [2] [3] The small package offers a small footprint, short wires for improved electrical connections, and good moisture reliability. [1] Some versions have an exposed pad on the bottom side.
TO-92 packages with pre-bent wires; on the left to emulate a TO-18 footprint (SO-97 in BS 3934, 10A3 in DIN 41868) The leads coming out of the case are spaced 0.05" (1.27 mm) apart. It is often convenient to bend them outward to a 0.10" (2.54 mm) spacing to make more room for wiring. [ 3 ]