Search results
Results From The WOW.Com Content Network
cmd.exe in Windows NT 2000, 4DOS, 4OS2, 4NT, and a number of third-party solutions allow direct entry of environment variables from the command prompt. From at least Windows 2000, the set command allows for the evaluation of strings into variables, thus providing inter alia a means of performing integer arithmetic. [26]
DevSlp or DevSleep (sometimes referred to as device sleep or SATA DEVSLP) is a feature in some SATA devices which allows them to go into a low power "device sleep" mode when sent the appropriate signal, which uses one or two orders of magnitude less power than a traditional idle (about 5 mW, [1] but some drives can get as low as 2.5 mW [2]).
Drives listed with "Loaded: No" are defaulting to the older, slower Bulk Only Transport (BOT) mode. This may occur if the drive's USB controller, the Mac's USB port, or any attached USB hub doesn't support UASP mode. The Linux kernel has supported UAS since 8 June 2014 when the version 3.15 was released. [18]
Toshiba calls it USB Sleep-and-Charge. [86] On Acer Inc. and Packard Bell laptops, sleep-and-charge USB ports are marked with a non-standard symbol (the letters USB over a drawing of a battery); the feature is called Power-off USB. [87] Lenovo calls this feature Always On USB. [88]
Device Sleep with a maximum return latency of 20 milliseconds unless otherwise specified in Identify Data Log; These can be selected by the SATA AHCI driver, usually via a configuration option, or by the OS Power Options. Windows Vista and later allows the tweaking of AHCI LPM modes through a registry hack. [3] Hot swapping is disabled.
Windows Vista introduced a hybrid sleep feature, which saves the contents of memory to hard disk but instead of powering down, enters sleep mode. If the power is lost, the computer can resume as if hibernated. Windows 7 introduced compression to the hibernation file and set the default size to 75% of the total physical memory. [18]
Advanced Configuration and Power Interface (ACPI) is an open standard that operating systems can use to discover and configure computer hardware components, to perform power management (e.g. putting unused hardware components to sleep), auto configuration (e.g. Plug and Play and hot swapping), and status monitoring.
However, since DOS and most DOS programs run in real mode (VCPI or DPMI makes a protected-mode program look like a real-mode program to DOS and the rest of the system by switching back and forth between the two modes), DOS TSRs and device drivers also run in real mode, and so any time one gets control, the DOS extender has to switch back to ...