Search results
Results From The WOW.Com Content Network
Note 2: A duplexer must provide adequate rejection of transmitter noise occurring at the receive frequency, and must be designed to operate at, or less than, the frequency separation between the transmitter and receiver. Note 3: A duplexer must provide sufficient isolation to prevent receiver desensitization. Source: from Federal Standard 1037C
The device is a tuned filter connected to the antenna. In this example, consider a type of device called a band-pass duplexer. It allows, or passes, a band, (or a narrow range,) of frequencies. There are two legs to the duplexer filter, one is tuned to pass the input frequency, the other is tuned to pass the output frequency.
A duplex communication system is a point-to-point system composed of two or more connected parties or devices that can communicate with one another in both directions. Duplex systems are employed in many communications networks, either to allow for simultaneous communication in both directions between two connected parties or to provide a reverse path for the monitoring and remote adjustment ...
Naval air traffic controller communicates with aircraft over a two-way radio headset A variety of portable handheld two-way radios for private use. A two-way radio is a radio transceiver (a radio that can both transmit and receive radio waves), which is used for bidirectional person-to-person voice communication with other users with similar radios, [1] in contrast to a broadcast receiver ...
Repeaters are found mainly in the VHF 6-meter (50–54 MHz), 2-meter (144–148 MHz), 1.25-meter band (1 1 ⁄ 4 meters) (220–225 MHz) and the UHF 70 centimeter (420–450 MHz) bands, but can be used on almost any frequency pair above 28 MHz. In some areas, 33 centimeters (902–928 MHz) and 23 centimeters (1.24–1.3 GHz) are also used for ...
The ports of a diplexer are frequency selective; the ports of a combiner are not. There is also a power "loss" difference - a combiner takes all the power delivered to the S port and equally divides it between the A and B ports. A diplexer does not. A diplexer frequency multiplexes two ports onto one port, but more than two ports may be ...
The simplest tone remote system uses a two-wire audio circuit to operate a simplex base station. If simultaneous transmit and receive is required, a four-wire or full duplex audio path to the base station is required. Systems using diversity combining (voting) require four-wire circuits.
Marantz 2050L AM/FM stereo tuner (USA; 1978-1980) [1]. In electronics and radio, a tuner is a type of receiver subsystem that receives RF transmissions, such as AM or FM broadcasts, and converts the selected carrier frequency into a form suitable for further processing or output, such as to an amplifier or loudspeaker.