Ads
related to: filco majestouch convertible 2 connect to pc transfer files setup guide
Search results
Results From The WOW.Com Content Network
A file transfer protocol is a convention that describes how to transfer files between two computing endpoints. As well as the stream of bits from a file stored as a single unit in a file system , some may also send relevant metadata such as the filename , file size and timestamp – and even file-system permissions and file attributes .
LapLink for Windows screenshot. Laplink (sometimes styled LapLink) is a proprietary software that was developed by Mark Eppley and sold by Traveling Software. [1] First available in 1983, [1] LapLink was used to synchronize, copy, or move, files between two PCs, in an era before local area networks, using the parallel port and a LapLink cable or serial port and a null modem cable [2] [3] [4 ...
The desktop computer hard-drive connector (AMP Mate-n-Lok 1-480424-0 power connector) is standard on all 5.25-inch floppy drives, 3.5-inch PATA and non-SCA SCSI disk drives; however, newer SATA disk drives employ a more advanced interconnection with 15 contacts. These advanced connection systems were first developed by Molex and other connector ...
Philco had developed and produced a miniature transistorized computer brain for the Navy's jet fighter planes in 1955 and it was called the "Transac" (C-1000, C-1100), which had stood for "Transistor Automatic Computer." The Philco Transac computer brain had used its high-frequency surface-barriers transistors in the circuitry design. [24] [25 ...
[2] KYK-28 pin gun used with the NESTOR (encryption) system; KYK-13 Electronic Transfer Device; KYX-15 Net Control Device [3] MX-10579 ECCM Fill Device [4] KOI-18 paper tape reader. Can read 8-level paper or PET tape, which is manually pulled through the reader slot by the operator. It is battery powered and has no internal storage, so it can ...
The typical sweet spot for IrDA communications is from 5 to 60 cm (2.0 to 23.6 in) away from a transceiver, in the center of the cone. IrDA data communications operate in half-duplex mode because while transmitting, a device's receiver is blinded by the light of its own transmitter, and thus full-duplex communication is not feasible.