Search results
Results From The WOW.Com Content Network
It is the same concept as volume percent (vol%) except that the latter is expressed with a denominator of 100, e.g., 18%. The volume fraction coincides with the volume concentration in ideal solutions where the volumes of the constituents are additive (the volume of the solution is equal to the sum of the volumes of its ingredients).
A molecular formula enumerates the number of atoms to reflect those in the molecule, so that the molecular formula for glucose is C 6 H 12 O 6 rather than the glucose empirical formula, which is CH 2 O. Except for the very simple substances, molecular chemical formulas generally lack needed structural information, and might even be ambiguous in ...
The ideal gas equation can be rearranged to give an expression for the molar volume of an ideal gas: = = Hence, for a given temperature and pressure, the molar volume is the same for all ideal gases and is based on the gas constant: R = 8.314 462 618 153 24 m 3 ⋅Pa⋅K −1 ⋅mol −1, or about 8.205 736 608 095 96 × 10 −5 m 3 ⋅atm⋅K ...
Some SI units of volume to scale and approximate corresponding mass of water. To ease calculations, a unit of volume is equal to the volume occupied by a unit cube (with a side length of one). Because the volume occupies three dimensions, if the metre (m) is chosen as a unit of length, the corresponding unit of volume is the cubic metre (m 3).
A class 8 truck is a heavy-duty truck as classified by the Department of Transportation's Federal Highway Administration. Pages in category "Class 8 trucks" The following 29 pages are in this category, out of 29 total.
For a substance X with a specific volume of 0.657 cm 3 /g and a substance Y with a specific volume 0.374 cm 3 /g, the density of each substance can be found by taking the inverse of the specific volume; therefore, substance X has a density of 1.522 g/cm 3 and substance Y has a density of 2.673 g/cm 3. With this information, the specific ...
The excluded volume of a hard sphere is eight times its volume—however, for a two-molecule system, this volume is distributed among the two particles, giving the conventional result of four times the volume; [2] this is an important quantity in the Van der Waals equation of state. The calculation of the excluded volume for particles with non ...
The surface-area-to-volume ratio has physical dimension inverse length (L −1) and is therefore expressed in units of inverse metre (m −1) or its prefixed unit multiples and submultiples. As an example, a cube with sides of length 1 cm will have a surface area of 6 cm 2 and a volume of 1 cm 3. The surface to volume ratio for this cube is thus