Ads
related to: mm to cm conversion chart
Search results
Results From The WOW.Com Content Network
The Charrière is measured by the ''outer'' diameter, and is defined as 1 Fr = 1/3 mm, and thus 1 mm = 3 Fr; therefore the diameter of a round catheter in millimetres can be determined by dividing the French size by 3. [2] The French units roughly correspond to the outer circumference of the catheter (see table below).
Conversion of units is the conversion of the unit of measurement in which a quantity is expressed, typically through a multiplicative conversion factor that changes the unit without changing the quantity. This is also often loosely taken to include replacement of a quantity with a corresponding quantity that describes the same physical property ...
The conversion between different SI units for one and the same physical quantity is always through a power of ten. This is why the SI (and metric systems more generally) are called decimal systems of measurement units. [10] The grouping formed by a prefix symbol attached to a unit symbol (e.g. ' km ', ' cm ') constitutes a new inseparable unit ...
Countries using the metric system tend to use lines per centimeter (L/cm). In order to convert between L/in and L/cm the following formulas can be used: Lines per inch to lines per cm: L/cm = 0.394 x L/in i.e. 254 L/in = 100 L/cm Lines per cm to lines per inch: L/in = 2.54 x L/cm i.e. 100 L/cm = 254 L/in
Table of length units. 1⁄12 of a ligne. This unit is usually called the Truchet point in English. Prior to the French Revolution the Fournier point was also in use. It was 1⁄6 of a ligne or 1⁄864 of the smaller French foot. 1⁄12 of a pouce. This corresponds to the line, a traditional English unit. 1⁄12 of a pied du roi.
Length. For measuring length, the U.S. customary system uses the inch, foot, yard, and mile, which are the only four customary length measurements in everyday use. From 1893, the foot was legally defined as exactly 1200⁄3937 m (approximately 0.304 8006 m). [13] Since July 1, 1959, the units of length have been defined on the basis of 1 yd = 0 ...