Search results
Results From The WOW.Com Content Network
A manual transmission (MT), also known as manual gearbox, standard transmission (in Canada, the United Kingdom and the United States), or stick shift (in the United States), is a multi-speed motor vehicle transmission system where gear changes require the driver to manually select the gears by operating a gear stick and clutch (which is usually ...
The clutch in a manual-shift motorcycle transmission is typically an arrangement of plates stacked in alternating fashion, one geared on the inside to the engine and the next geared on the outside to the transmission input shaft. Whether wet (rotating in engine oil) or dry, the plates are squeezed together by springs, causing friction build up ...
The Multimode Manual Transmission has the following gears: R, N, E, M+, M−. R: R is the reverse gear. It is similar to R in both traditional manual and in fully automatic cars. N: N is the neutral gear. It is similar to N in both traditional manual and full automatic. E: E is the functional equivalent of D in a full automatic.
PSR-OR700 (2007, Oriental version of Yamaha PSR-S700) PSR-A2000 (2012, Oriental model and black version of Yamaha PSR S710. And the first A series whose Pitch Band and Modulation uses a Joystick) PSR-A3000 (2016, Oriental version based on Yamaha PSR-S770 and first A Series to have multiple colours in the board)
Basically there are two types of motor vehicle transmissions: Manual – the driver has to perform each gear change using a manually operated clutch; Automatic – once placed in drive (or any other 'automatic' selector position), it automatically selects the gear ratio dependent on engine speed and load
Gear shift lever on a motorcycle (above the toe of the rider's boot) A sequential manual transmission is unsynchronized, and allows the driver to select either the next gear (e.g. shifting from first gear to second gear) or the previous gear (e.g., shifting from third gear to second gear), operated either via electronic paddle-shifters mounted behind the steering wheel or with a sequential ...
In 1891, the French Panhard et Levassor automobile used a three-speed manual transmission and is considered to have set the template for multi-speed manual transmissions in motor vehicles. [3] [4] This transmission used a sliding-gear design without any form of speed synchronization, causing frequent grinding of the gear teeth during gear ...
A close-ratio transmission is one which is described relative to another transmission for the same vehicle model. The relativity applies only for the transmissions offered for a single make and model; that is, there is no specific threshold value or accepted industry standard that determines whether the steps between gears constitute a normal or close-ratio transmission.