Search results
Results From The WOW.Com Content Network
nslookup is a member of the BIND name server software. Andrew Cherenson created nslookup as a class project at UC Berkeley in 1986 and it first shipped in 4.3-Tahoe BSD [1] In the development of BIND 9, the Internet Systems Consortium planned to deprecate nslookup in favor of host and dig.
The original list of IPv4 address blocks was published in September 1981. [3] In previous versions of the document, [19] [20] network numbers were 8-bit numbers rather than the 32-bit numbers used in IPv4. At that time, three networks were added that were not listed earlier: 42.rrr.rrr.rrr, 43.rrr.rrr.rrr, and 44.rrr.rrr.rrr.
Most socket functions, such as accept() and getpeername(), require the parameter to have type socklen_t * and programmers often pass the address to the ai_addrlen element of the addrinfo structure. If the types are incompatible, e.g., on a 64-bit Solaris 9 system where size_t is 8 bytes and socklen_t is 4 bytes, then run-time errors may result.
Hex Protocol Number Keyword Protocol References/RFC; 0x00 0 HOPOPT IPv6 Hop-by-Hop Option: RFC 8200: 0x01 1 ICMP Internet Control Message Protocol: RFC 792: 0x02 2 IGMP Internet Group Management Protocol: RFC 1112: 0x03 3 GGP Gateway-to-Gateway Protocol: RFC 823: 0x04 4 IP-in-IP IP in IP (encapsulation) RFC 2003: 0x05 5 ST Internet Stream ...
8+: <0–3 bytes padding>, defaultbyte1, defaultbyte2, defaultbyte3, defaultbyte4, npairs1, npairs2, npairs3, npairs4, match-offset pairs... key → a target address is looked up from a table using a key and execution continues from the instruction at that address lor 81 1000 0001 value1, value2 → result bitwise OR of two longs lrem 71 0111 0001
The Link-Local Multicast Name Resolution (LLMNR) is a protocol based on the Domain Name System (DNS) packet format that allows both IPv4 and IPv6 hosts to perform name resolution for hosts on the same local link.
Special address blocks Address block Address range Number of addresses Scope Description 0.0.0.0/8 0.0.0.0–0.255.255.255 16 777 216: Software Current (local, "this") network [1] 10.0.0.0/8 10.0.0.0–10.255.255.255 16 777 216: Private network Used for local communications within a private network [3] 100.64.0.0/10 100.64.0.0–100.127.255.255 ...
It is important to note that this is the reverse order to the usual dotted-decimal convention for writing IPv4 addresses in textual form. For example, to do a reverse lookup of the IP address 8.8.4.4 the PTR record for the domain name 4.4.8.8.in-addr.arpa would be looked up, and found to point to dns.google.