Search results
Results From The WOW.Com Content Network
All components of a design, The functionality of each component, The failure modes of each component, The effect of each component failure mode on the product functionality, The ability of any automatic diagnostics to detect the failure, The design strength (de-rating, safety factors), The impact of any latent fault tests, and
Fault detection, isolation, and recovery (FDIR) is a subfield of control engineering which concerns itself with monitoring a system, identifying when a fault has occurred, and pinpointing the type of fault and its location. Two approaches can be distinguished: A direct pattern recognition of sensor readings that indicate a fault and an analysis ...
Before detailed analysis takes place, ground rules and assumptions are usually defined and agreed to. This might include, for example: Standardized mission profile with specific fixed duration mission phases; Sources for failure rate and failure mode data; Fault detection coverage that system built-in test will realize
All the potential causes for a failure mode should be identified and documented. This should be in technical terms. Examples of causes are: Human errors in handling, Manufacturing induced faults, Fatigue, Creep, Abrasive wear, erroneous algorithms, excessive voltage or improper operating conditions or use (depending on the used ground rules).
Failure analysis is the process of collecting and analyzing data to determine the cause of a failure, often with the goal of determining corrective actions or liability.. According to Bloch and Geitner, ”machinery failures reveal a reaction chain of cause and effect… usually a deficiency commonly referred to as the symptom…”
ATPG (acronym for both automatic test pattern generation and automatic test pattern generator) is an electronic design automation method or technology used to find an input (or test) sequence that, when applied to a digital circuit, enables automatic test equipment to distinguish between the correct circuit behavior and the faulty circuit behavior caused by defects.
Other guidelines, for example, deal with the electromechanical characteristics of the interface between the product under test and the test equipment. Examples are guidelines for the size, shape, and spacing of probe points, or the suggestion to add a high-impedance state to drivers attached to probed nets such that the risk of damage from back ...
Fault reporting is an optional feature that can be forwarded to remote displays using simple configuration setting in all modern computing equipment. The system level of reporting that is appropriate for Condition Based Maintenance are critical, alert, and emergency, which indicate software termination due to failure.